QUICK START GUIDE FOR DEMONSTRATION CIRCUIT DC806
OCTAL 16 BIT 200KSPS ADC
3
HARDWARE SET-UP
JUMPERS
JP1
– Select reference, either internal or the onboard
LT1019 reference.
ANALOG CONNECTIONS (TURRET POSTS)
GND
(3X) – Ground plane connections. DC806 can
also be grounded to an application circuit by the ex-
posed ground planes at the edges of the board.
CH0 – CH7/COM
– Analog inputs to LTC1859. Each
input has a 100 / 1000pF filter to reduce wideband
noise pickup.
VREF
– Reference pin on LTC1859. When JP2 is set to
INT, the LTC1867 uses its internal reference, or an ex-
ternal reference can be connected to this pin, overdriv-
ing the internal reference. When JP2 is set to LT1019,
this turret should only be used for monitoring the ref-
erence voltage.
GROUNDING AND POWER CONNECTIONS
DC806 does not require any external power source
when used with the DC590 USB controller board.
However, an external 5V power source can be con-
nected to the Vcc and ground turrets if the power sup-
ply on DC590 has been disabled. Refer to the DC590
quick start guide for more information.