SPECIFICATION
320W Constant Current Mode LED Driver
HVGC-320 series
File Name:HVGC-320-SPEC 2018-05-29
MODEL
RATED CURRENT
RATED POWER
OUTPUT
CURRENT ADJ. RANGE
VOLTAGE RANGE
Note.3
FREQUENCY RANGE
POWER FACTOR (Typ.)
EFFICIENCY (Typ.)
AC CURRENT (Typ.)
INPUT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
SAFETY STANDARDS
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
OVER VOLTAGE
OVER TEMPERATURE
Adjustable for A/AB-Type only (via built-in potentiometer)
47 ~ 63Hz
1.1A / 347VAC 0.8A / 480VAC
<0.75mA / 480VAC
Compliance to FCC Part 15 Subpart B, EAC TP TC 020
Compliance to EN61000-4-2,3,4,5,6,8,11, EN61547, light industry level surge immunity Line-Earth 4KV, Line-Line 2KV , criteria A, EAC TP TC 020()
20 ~ 95% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH
℃
±℃ ℃
0.03%/ (0 ~ 60 )
10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
UL8750 (type”HL”), CSA C22.2 No. 250.13-12, EAC TP TC 004 IP65 or IP67 approved,
141.2K hrs min. MIL-HDBK-217F (25 )℃
262*90*43.8mm (L*W*H)
ENVIRONMENT
SAFETY &
EMC
PROTECTION
SHORT CIRCUIT
445 ~ 455V
320 ~ 351V
160 ~ 175V
240 ~ 263V
192 ~ 210V 120 ~ 131V 96 ~ 105V
93.5%
93.5%
93.5%93.5% 93.5% 93.5% 93%
350~700mA 525~1050mA 700~1400mA
875~1750mA
1050~2100mA
1400~2800mA
1750~3500mA
700mA
HVGC-320-700
HVGC-320-1050
HVGC-320-1400
HVGC-320-1750
HVGC-320-2100
HVGC-320-2800
HVGC-320-3500
214 ~ 428V
1050mA
152.4 ~ 304.8V
2100mA
76.2 ~ 152.4V
300W 320W 320W 320W 320W 320W 320W
2800mA 3500mA
57 ~ 114.3V 45.7 ~ 91.4V
1400mA 1750mA
114.3 ~ 228.6V
91.4~182.8V
EMC IMMUNITY
EMC EMISSION
COLD START 50A(t =920 s measured at 50% I ) at 480VAC;
width peak Per NEMA 410
TOTAL HARMONIC DISTORTION
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:1.5KVAC
I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH
℃
CONSTANT CURRENT REGION
Note.2
PACKING
2Kg; 8pcs/17Kg/0.92CUFT
NOTE
μ
MAX. NO. of PSUs on 16A
CIRCUIT BREAKER
2 unit(circuit breaker of type B) / 4 units(circuit breaker of type C) at 480VAC
Shut down o/p voltage with re-power on to recovery
OPEN CIRCUIT VOLTAGE (max.)
442V 311V 234V 187V 156V 118V 94V
Constant current limiting, recovers automatically after fault condition is removed
Shut down and latch off o/p voltage, re-power on to recover
1. All parameters NOT specially mentioned are measured at 347VAC input, rated current and 25 of ambient temperature.℃
2. Please refer to "DRIVING METHODS OF LED MODULE".
3. De rating may be needed under low input voltages. Please .- refer to STATIC CHARACTERISTIC sections for details
4. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time.
5. The is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the driver
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6. This series meets the typical life expectancy of >50,000 hours of operation when Tcase, particularly tc point (or TMP, per DLC), is about 80 or less. ℃
7. Please refer to the warranty statement on MEAN WELL's website at http://www.meanwell.com.
8. The ambient temperature derating of 3.5 /1000m with fanless models and of 5 /1000m with fan models for operating altitude higher than 2000m(6500ft).℃℃
WORKING TEMP.
Tcase=-40 ~ +90 (Please refer to "OUTPUT LOAD vs TEMPERATURE" section)℃
MAX. CASE TEMP.
Tcase=+90℃
PF 0.9 /230VAC, PF 0.9 /277VAC full load≧≧≧≧8 7 , PF 0.95/347VAC, PF 0.93/480VAC @
(Please refer to " " )POWER FACTOR (PF) CHARACTERISTIC section
THD< 20%(@ load 50%/230VAC, 277VAC, 347VAC, @ load 60%/480VAC)≧≧
(Please refer to “TOTAL HARMONIC DISTORTION (THD)” section)
CURRENT RIPPLE 5.0% max. @rated current
CURRENT TOLERANCE ±
5%
180 ~ 528VAC 254VDC ~ 747VDC
(Please refer to "STATIC CHARACTERISTIC" section)
SET UP TIME Note.4 500ms/230VAC, 347VAC, 480VAC
