www.switches-sensors.zf.com
Page 1 of 2, last update 2017-01-05, Specifications subject to change without notice.
#NP#_TY9vb4IwEM a/CumrLZPZFl DwHZ2dYQ7E P5vDNCGV 4mxGqKHVLDF+ 95XtzS655 O653+XuuYK qApMr6A6JAB OAIILgNrBi37HhlJv 6DvmhF+A RRgGE8MEmv GdDMA BC9pvcgt82rLDv 61RW ndLqYJyt6kSPJV MrkyLYZXHw QecLCItiNQtf3n dpEWbYIoeT JYoJY1/aeL49 wJhshbxIceY NY+StTGg5a9SeN +WaN7 Uuk1actelkL6jm bKRqN WN5vnJeN5kTr 4ijj7yrGbM OuD7WtbHjdd1 q1dmCtp+ N1Md/0zLO opJmj0JVvZPT3 9PPGU7jfIbHI zyaL3O42K KlV+B0E1rG/CIheYr INCKuhyh 2fRqN3ZhQ6B LohcjHEbYJ brcf_#NP#
Angle Position Sensors
AN9 Sensors
Thin, programmable, non-contact magnetic position sensors
capable of continuous rotation with dual outputs
Description
The AN9 Series sensors are non-contact, intrinsically linear angle position sensors with two independent outputs. The sensors
operate through the use of Hall Effect technology with magnetic fields generated by permanent magnets. They provide a linear
change in voltage output (ratiometric to the input voltage) corresponding to an angular rotation of the input shaft.
Angular position sensor with high tolerance for misalignment
Non-contact angular position sensing and full 360° rotation
Dual independent (fully redundant) outputs assure high reliability
Custom programming available for: angle range, slope, PWM
output, custom magnets – contact factory
No mechanical interface means no parts to wear out or jam
Comes with 18 AWG 305 mm (12”) wire leads
RoHS Compliant
IP68*
Maximum air gap of 5.5 mm (0.22”)**
Implement (fork lift, agricultural trailer hitch,
etc.) position sensing
Steer, throttle by wire
Gear selection
Zero-contact encoder alternative
Replacement for smart bearings
Outboard trim sensing
Environmental Specifications
15g sinusoidal, 9.26g RMS axial; 40 Hz – 2 kHz all 3 axes
-40 °C to 125 °C (-40 °F to 257 °F)
-40 °C to 150 °C (-40 °F to 302 °F)
*submerged in 22±3 °C water for 1 hour at 2 m depth
Electrical Specifications
10% to 90% of input (see graph for voltage vs. rotation angle
characteristics)
Absolute Max. Output Current
Mechanical Specifications
**with AS500106 magnet carrier
Maximum Center-To Center Offset
2 mm radial (magnet to center)
Note: When used with AS500106 Magnet Carrier; user is responsible for determining characteristics when using other magnets.
