This enclosure was designed by Mike Doell. It's made of ultra-durable, super-glossy polycarbonate, and is
both good looking and tough enough to toss into your bookbag or toolbox. It has slim openings for all your
cables, an easy-to-remove beveled slot for your Micro SD card, slots for both your Pi Camera and
upcoming Display, and a space for your GPIO cable to extend out from the Pi.
The Pi snaps into the base and the lid fits snugly onto the top. If you want to break out your Pi you can use
your case without the lid and add hats to your B+ with ease.
This case works for the Raspberry Pi Model B+ / Pi 2 only. It does not work for the Raspberry Pi
Model A or B. It does work with the model A+ but there will be a bit of empty space of course, and you'll
need to snake your USB cable or connector through the front holes which may not work if the cable is
bulky.
No Raspberry Pi included. This is just the base of the case and no lid is included.
Here's how to insert a Raspberry Pi into our case:
Technical Details
o Dimensions:92mmx63mmx26mm/3.6"x2.5"x1.0"
o Weight:28g
o RevisionHistory:AsofMarch4th,2015thecoloronthisbasehasslightlychanged.
EngineeredinNYCAdafruit®
