NPF-40 series
SPECIFICATION
MODEL
OUTPUT
VOLTAGE RANGE
Note.5
FREQUENCY RANGE
POWER FACTOR
EFFICIENCY (Typ.)
AC CURRENT
INPUT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
EMC IMMUNITY
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
OVER TEMPERATURE
OVER VOLTAGE
47 ~ 63Hz
Compliance to
EN55015
,EN61000-3-2 Class C (@load 60%) ;≧
EN61000-3-3;EAC TP TC 020
20 ~ 95% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH℃
±℃ ℃0.03%/ (0 ~ 50 )
10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
1179.7K hrs min. Telcordia SR-332 (Bellcore) ; 68Khrs min. MIL-HDBK-217F (25 )3 ℃
ENVIRONMENT
EMC EMISSION
Note.8
SAFETY &
EMC
PROTECTION
SHORT CIRCUIT
I/P-O/P:3.75KVAC
I/P-O/P:100M Ohms / 500VDC / 25 / 70% RH℃
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
File Name:NPF-40-SPEC 2018-01-09
TOTAL HARMONIC DISTORTION
DC VOLTAGE
RATED CURRENT
RATED POWER
Note.5
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME
Note.6
HOLD UP TIME (Typ.)
RIPPLE & NOISE (max.)
Note.3
VOLTAGE TOLERANCE
Note.4
CONSTANT CURRENT REGION
Note.2
OVER CURRENT
SAFETY STANDARDS Note.8
COLD START 50A(twidth=270 s measured at 50% Ipeak) at 230VACμ;Per NEMA 410
MAX. No. of PSUs on 16A
CIRCUIT BREAKER
9 units (circuit breaker of type B) / 16 units (circuit breaker of type C) at 230VAC
MAX. CASE TEMP.
Tcase=+85℃
Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level ( )surge immunity Line-Line 2KV
;EAC TP TC 020
(Please refer to "STATIC CHARACTERISTIC" section)
90 ~ 305VAC 127 ~ 431VDC
1. All parameters NOT specially mentioned are measured at 230VAC input, rated and 25 of ambient temperature.current ℃
2. Please refer to "DRIVING METHODS OF LED MODULE".
3. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
4. Tolerance : includes set up tolerance, line regulation and load regulation.
5. De rating may be needed under low input voltages. Please .- refer to STATIC CHARACTERISTIC sections for details
6. Length of set up time is measured at first cold start. Turning ON/OFF the driver may lead to increase of the set up time.
7. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
8. The model certified for CCC(GB19510.14, GB19510.1, GB17743 and GB17625.1) is an optional model . Please contact MEAN WELL for details.
9. This series meets the typical life expectancy of >50,000 hours of operation when Tcase, particularly tc point (or TMP, per DLC), is about 75 or less.℃
10. Please refer to the warranty statement on MEAN WELL's website at http://www.meanwell.com
40W Constant Voltage + Constant Current LED Driver
95 ~ 108%
Hiccup mode, recovers automatically after fault condition is removed
Constant current limiting, recovers automatically after fault condition is removed
PF 0.97/115VAC, PF 0.95/230VAC, PF 0.92/277VAC@full load≧≧≧
(Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section)
THD< 20%(@load 60%/115VC,230VAC; @load 75%/277VAC)≧≧
(Please refer to “TOTAL HARMONIC DISTORTION(THD)” section)
Tcase=-40 ~ +85 (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section)℃
Shut down o/p voltage, re-power on to recover
12V 15V 20V 24V 30V
36V
48V 54V
42V
NPF-40-12 NPF-40-15 NPF-40-20 NPF-40-24 NPF-40-30 NPF-40-36 NPF-40-42 NPF-40-48 NPF-40-54
16ms/230VAC 16ms/115VAC
500ms, 80ms 115VAC / 230VAC
<0.25mA / 277VAC
17.5 ~ 21V15 ~ 17V
23 ~ 27V
28 ~ 34V
34 ~ 40V
41 ~ 46V 54 ~ 60V
46 ~ 54V 59 ~ 66V
UL8750(type”HL”), CSA C22.2 No. 250.13-12, ENEC EN61347-1, EN61347-2-13 independent, EN62384,
UL879(for 12V,24V only),
EAC TP TC 004,IP67 approved; Design refer to EN60335-1
150*53*35mm (L*W*H)
0.49Kg;30pcs/15.7Kg/1.0CUFT
<0.15W
NO LOAD POWER CONSUMPTION
±4.0%±4.0% ±4.0% ±3.0% ±3.0% ±2.0% ±1.0% ±1.0% ±1.0%
±0.5%±0.5% ±0.5% ±0.5% ±0.5%
±0.5%
±0.5%
±1.0%±1.5% ±1.0% ±0.5% ±0.5%
±0.5%
±0.5%
±0.5%
±0.5%
±0.5%
±0.5%
150mVp-p150mVp-p 150mVp-p 150mVp-p 200mVp-p
200mVp-p
200mVp-p 350mVp-p
200mVp-p
2.67A3.34A 2A 1.67A
1.12A
0.84A
40.08W40.08W 40W 40.08W 40.2W
40.32W
40.32W
0.76A
41.04W
0.96A
40.32W
9 ~ 15V7.2 ~ 12V 12 ~ 20V 14.4 ~ 24V 18 ~ 30V
21.6 ~ 36V
28.8 ~ 48V 32.4 ~ 54V
25.2 ~ 42V
1.34A
87%86%
88%
89%
89%
90%
90%90% 90%
0.6A / 115VAC 0.3A / 230VAC 0.25A / 277VAC
Shut down o/p voltage, re-power on to recover
