Properties Typical Value Test Method
Thickness*
0.063ʺ (1.6 mm) ±0.005"
Color* Green/Black
Light Blue/Black
Gray/Black
Dark Blue/Black
Resistances
Surface to Ground (Rtg)
Surface to Surface (Rtt)
1 x 10
6
to < 1 x 10
9
ohms
1 x 10
6
to < 1 x 10
9
ohms
ANSI/ESD S4.1, ESD TR53
ANSI/ESD S4.1, ESD TR53
Hardness 65 ± 5 Shore “A” ASTM-D2240
Tolerance
Mat Kit
Rolls
Width +/- 0.250"
Length +/- 1"
Width +/- 0.250"
Length +/- 2"
*Color, texture and thickness may vary between lots and mills.
Matting materials have a tendency to shrink slightly when rst unrolled. In applications where
length is critical, allow the material to condition for at least 4 hours before cutting to size.
Always using care, trim with a sharp knife or razor blade.
R3 Dissipative Rubber Worksurface Mat
Meets ANSI/ESD S20.20 worksurface required limit (and recommendation
of ANSI/ESD S4.1) tested per ANSI/ESD S4.1 and ESD TR53. Resistance
to solvents, hot solder and soldering irons makes the R3 Dissipative Rubber
Worksurface Mat a versatile static-safe worksurface. Electrical performance
is accomplished by using a two-layer rubber combination of a static
dissipative colored top with a conductive black bottom. Compatible with
Continuous Workstation Monitors. Available in rolls and mat kits.
DRAWING
NUMBER
R3 Series
DATE
January
2018
© 2018 DESCO INDUSTRIES INC.
Employee Owned
R3 DISSIPATIVE RUBBER WORKSURFACE MAT
926 JR Industrial Drive, Sanford, NC 27332
WEB SITE: StaticControl.com
PHONE (919) 718-0000
Roll Item Numbers
Size Light Blue Gray Green Dark Blue
2' x 50'
(0.6 m x 15.2 m)
770070 770086 770081 770091
2.5' x 50'
(0.8 m x 15.2 m)
770071 770087 770082 770092
3' x 50'
(0.9 m x 15.2 m)
770072 770088 770083 770093
4' x 50'
(1.2 m x 15.2 m)
770073 770089 770084
Includes roll of
matting material.
Made in the
United States of America
Table Mat Kit Item Numbers
Table Mat Kit Includes:
1 Table Mat, size as specified
1 LPCGC151M 15' (4.6 m) Ground Cord
2 3049 Snap Kit
Size Light Blue Gray Green
24" x 48"
(0.6 m x 1.2 m)
770074 770090 770085
Specifications and procedures subject to change without notice.
Grounding: This material must be properly grounded for optimum electrical
performance. See Grounding Cords.
Cleaning: For optimum electrical performance, surface must be cleaned
regularly using a recommended ESD mat cleaner. Do not use cleaners with
silicone. Silicone buildup will create an insulative lm on the surface.
Mat Kits are laser engraved for
branding and auditing purposes.
Light Blue
Gray
Dark Blue