AD5204/AD5206 Data Sheet
Rev. D | Page 4 of 20
Parameter Symbol Test Conditions/Comments Min Typ
1
Max Unit
INTERFACE TIMING CHARACTERISTICS
7, 11, 12
Input Clock Pulse Width t
CH
, t
CL
Clock level high or low 20 ns
Data Setup Time t
DS
5 ns
Data Hold Time t
DH
5 ns
CLK-to-SDO Propagation Delay
13
t
PD
R
L
= 2 kΩ , C
L
< 20 pF 1 150 ns
CS Setup Time
t
CSS
15 ns
CS High Pulse Width
t
CSW
40 ns
Reset Pulse Width t
RS
90 ns
CLK Fall to CS Fall Setup
t
CSH0
0 ns
CLK Fall to CS Rise Hold Time
t
CSH1
0 ns
CS Rise to Clock Rise Setup
t
CS1
10 ns
1
Typicals represent average readings at 25°C and V
DD
= 5 V.
2
Applies to all VRs.
3
Resistor position nonlinearity error (R-INL) is the deviation from an ideal value measured between the maximum resistance and the minimum resistance wiper positions.
R-DNL measures the relative step change from the ideal position between successive tap positions. Parts are guaranteed monotonic. See the test circuit in Figure 28.
I
W
= V
DD
/R for both V
DD
= 3 V and V
DD
= 5 V.
4
V
AB
= V
DD
, wiper (V
W
) = no connect.
5
INL and DNL are measured at V
W
with the RDAC configured as a potentiometer divider similar to a voltage output DAC. V
A
= V
DD
and V
B
= 0 V. DNL specification limits
of ±1 LSB maximum are guaranteed monotonic at operating conditions. See the test circuit in Figure 27.
6
Resistor Terminal A, Terminal B, and Wiper W have no limitations on polarity with respect to each other.
7
Guaranteed by design and not subject to production test.
8
Measured at the Ax terminals. All Ax terminals are open circuited in shutdown mode.
9
P
DISS
is calculated from (I
DD
× V
DD
). CMOS logic level inputs result in minimum power dissipation.
10
All dynamic characteristics use V
DD
= 5 V.
11
Applies to all parts.
12
See the timing diagrams (Figure 3 to Figure 5) for the location of the measured values. All input control voltages are specified with t
R
= t
F
= 2.5 ns (10% to 90% of 3 V)
and timed from a voltage level of 1.5 V. Switching characteristics are measured using both V
DD
= 3 V and V
DD
= 5 V.
13
The propagation delay depends on the values of V
DD
, R
L
, and C
L
(see the Operation section).