SPEC NO: DSAG7623 REV NO: V.12A DATE: MAY/18/2016 PAGE: 2 OF 6
APPROVED: Wynec CHECKED: Allen Liu DRAWN: M.Liu ERP: 1203005979
Selection Guide
Absolute Maximum Ratings at TA=25°C
Electrical / Optical Characteristics at TA=25°C
Part No. Emitting Color (Material) Lens Type
Iv (mcd) [2]
@ 20mA
iewing
Angle [1]
Min. Typ. 2θ1/2
APHBM2012SURKCGKC
Hyper Red (AlGaInP)
Water Clear
120 250
120
°
*40 *80
20 50
*20 *50
Green (AlGaInP)
Symbol Parameter Emitting Color Typ. Max. Units Test Conditions
λpeak Peak Wavelength
Hyper Red
Green
645
574
nm I
F=20mA
λD [1] Dominant Wavelength
Hyper Red
Green
630
570
nm I
F=20mA
Δλ1/2 Spectral Line Half-width
Hyper Red
Green
28
20
nm I
F=20mA
C Capacitance
Hyper Red
Green
35
15
pF V
F=0V;f=1MHz
V
F [2] Forward Voltage
Hyper Red
Green
1.95
2.1
2.5
2.5
V I
F=20mA
I
R Reverse Current
Hyper Red
Green
10
10
uA V
R = 5V
Parameter Hyper Red Green Units
Power dissipation 75 75 mW
DC Forward Current 30 30 mA
Peak Forward Current [1] 185 150 mA
Reverse Voltage 5 V
Operating Temperature -40°C To +85°C
Storage Temperature -40°C To +85°C
Notes:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
2. Luminous intensity / luminous Flux: +/-15%.
* Luminous intensity value is traceable to CIE127-2007 standards.
Notes:
1. Wavelength: +/-1nm.
2. Forward Voltage: +/-0.1V.
3. Wavelength value is traceable to CIE127-2007 standards.
4. Excess driving current and / or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static
electricity – Ref JEDEC/JESD625-A and JEDEC/J-STD-033.
