MAX. No. of PSUs on 16A
CIRCUIT BREAKER
5 units (circuit breaker of type B) / 9 units (circuit breaker of type C) at 230VAC
SPECIFICATION
MODEL APC-35-350
APC-35-700
DC VOLTAGE RANGE
RATED CURRENT
RATED POWER
OUTPUT
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME
VOLTAGE RANGE
Note.4
FREQUENCY RANGE
EFFICIENCY(Typ.)
AC CURRENT
INPUT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
OVER VOLTAGE
28~100V
15~50V
350mA
700mA
35W
35W
350mVp-p
350mVp-p
±5.0%
±1.0%
±3.0%
1500ms, 40ms / 230VAC 1500ms, 40ms / 115VAC at full load
47 ~ 63Hz
84%
84%
0.5A/230VAC;0.75A/115VAC
0.25mA / 240VAC
20 ~ 90% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH℃
±℃ ℃0.2%/ (0 ~ 50 )
10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.℃
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltage. Please check the static characteristic for more details.
5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6.The unit might not be suitable for lighting applications in EU countries. Please check with your local authorities for the possible use of the unit.
35W Single Output Switching Power Supply
Constant current mode power supply
Universal AC input / Full range
Withstand 300VAC Surge input for 5 seconds
Protections:Short circuit / Over voltage
Fully isolated plastic case
Small and compact size
Cooling by free air convection
IP42 design
100% full load burn-in test
Suitable for LED related fixture or appliance
(such as LED Decoration or Advertisement devices)
Low cost / High reliability
2 years warranty
RIPPLE & NOISE (max.) Note.2
VOLTAGE TOLERANCE Note.3
ENVIRONMENT
SAFETY &
EMC
(Note 5)
PROTECTION
File Name: APC-35-SPEC 2018-01-05
SAFETY STANDARDS
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
I/P-O/P:3KVAC
HOLD UP TIME (Typ.) 20ms/230VAC 12ms/115VAC at full load
110 ~ 130V
55 ~ 65V
Protection type : Shut down o/p voltage, re-power on to recover
84*57*29.5(L*W*H)
COLD START 45A(twidth=490 s measured at 50% Ipeak) at 230VACμ
518.9K hrs min. MIL-HDBK-217F (25 )℃
■ Features :
I/P-O/P:>100M Ohms / 500VDC / 25 / 70% RH℃
90 ~ 264VAC 127 ~ 370VDC
APC-35 series
UL8750 (only for APC-35-700&1050), CSA-C22.2 No. 250.0-13 (only for APC-35-1050), BIS IS15885, EAC TP TC 004,
IP42 approved; design refer to EN60950-1
( only for APC-35-700)
(only for APC-35-1050)
CURRENT ACCURACY
±8.0%
EMC IMMUNITY
Compliance to EN55032,EN61000-3-2 Class A,EN61000-3-3, EAC TP TC 020
Compliance to EN55024,EN61000-4-2,3,4,5,6,8,11; light industry level(surge 2KV), criteria A, EAC TP TC 020
EMC EMISSION
APC-35-500
25~70V
500mA
35W
350mVp-p
84%
77 ~ 91V
APC-35-1050
11~33V
1050mA
34.7W
350mVp-p
84%
36 ~ 43V
-30 ~ 70 (Refer to "Derating Curve")℃
0.18Kg; 72pcs/14Kg/0.92CUFT
LPS (except for APC-35-350,APC-35-500)
IP42
IS 15885(Part 2/Sec13)
R-41027766
THOMAS SAMUEL
THOMAS SAMUEL
