MK2745-24STR

DATASHEET
DVD/MPEG CLOCK SOURCE MK2745-24
IDT™
DVD/MPEG CLOCK SOURCE 1
MK2745-24 REV E 122109
Description
The MK2745-24 is a low-cost, low-jitter, high-performance
clock synthesizer for DVD and other MPEG 2-based
applications. Using analog Phase-Locked Loop (PLL)
techniques, the device accepts a 27 MHz fundamental
mode crystal or clock input to produce multiple audio output
clocks, a processor clock, and two 27 MHz clocks. The
audio clocks are frequency-locked to the 27 MHz using our
patented zero ppm error techniques. This allows audio and
video to track exactly, thereby eliminating the need for large
buffer memory.
IDT manufactures a large variety of DVD, Set-top Box, and
multiimedia clock synthesizers for all applications. Consult
IDT to eliminate crystals and oscillators from your board.
Features
Packaged in a 16-pin narrow (150 mil) SOIC
Ideal for AuraVision’s notebook DVD solutions
Patented zero ppm audio clock error for exact audio clock
sampling rates, plus 32x and 256x clocks of the sampling
frequencies
Selectable audio sampling frequencies support 32, 44.1,
and 96 kHz in most DACs
27 MHz fundamental crystal or clock input
Selectable processor frequencies
Two clocks of 27 MHz
Zero ppm in all clocks
25 mA output drive capability at TTL levels
Advanced, low-power, sub-micron CMOS process
Operating voltage of 3.3 V to 5 V
See also the MK2712 for NTSC/PAL clocks
NOTE: EOL for non-green parts to occur on 5/13/10
per PDN U-09-01
Block Diagram
CLKA4
CLKB1
CLKA3
CLKB2
CLKB3
CLKA2
CLKA1
CLKB4
Control
Logic
S2, S1
2
PLL
FBIN
CLKIN
/2
VDD
2
GND
2
BANK
A
BANK
B
MK2745-24
DVD/MPEG CLOCK SOURCE VCXO AND SYNTHESIZER
IDT™
DVD/MPEG CLOCK SOURCE 2
MK2745-24 REV E 122109
Pin Assignment Feedback Configuration Table
Output Clock Mode Select Table
Pin Descriptions
1
2
3
GND
4
CLKA1
5
6
CLKA4
7
8
CLKA3
VDD
CLKB3CLKB2
FBIN
CLKB1
S1
CLKA2
16
CLKIN
VDD
S2
CLKB4
GND
15
14
13
12
11
10
9
16-pin (150 mil) SOIC
Feedback From CLKA1:A4 CLKB1:B4
Bank A CLKIN CLKIN/2
Bank B 2XCLKIN CLKIN
S2 S1 Clocks A1:A4 Clocks B1:B4 Internet Generation PLL Status
0 0 Tri-state (high impedance) Tri-state (high impedance) None On
0 1 Running Tri-state (high impedance) PLL On
1 0 Running Running Buffer only (no zero delay) Off
1 1 Running Running PLL On
Pin
Number
Pin
Name
Pin
Type
Pin Description
1 CLKIN Input Clock input. Connect to input clock source.
2, 3 CLKA1:A4 Output Clock A bank of four outputs.
4 VDD Power Power supply. Connect pin to same voltage as pin 13 (either 3.3 V or 5 V).
5 GND Power Connect to ground.
6, 7 CLKB1:B4 Output Clock B bank of four outputs. These are low skew divide by two of bank A.
8 S2 Input Select input 2. Selects mode for outputs per table above.
9 S1 Input Select input 1. Selects mode for outputs per table above.
10, 11 CLKB1:B4 Output Clock B bank of four outputs. These are low skew divide by two of bank A.
12 GND Power Connect to ground.
13 VDD Power Power supply. Connect pin to same voltage as pin 4 (either 3.3 V or 5 V).
14, 15 CLKA1:A4 Output Clock A bank of four outputs.
16 FBIN Input Feedback input. Determines outputs per table above.
MK2745-24
DVD/MPEG CLOCK SOURCE VCXO AND SYNTHESIZER
IDT™
DVD/MPEG CLOCK SOURCE 3
MK2745-24 REV E 122109
External Components
The MK2745-24 requires a minimum number of external components for proper operation. Decoupling capacitors
of 0.1µF should be connected between VDD and GND, as close to the part as possible. A 33 series terminating
resistor should be used on each clock output to reduce reflections.
Absolute Maximum Ratings
Stresses above the ratings listed below can cause permanent damage to the MK2745-24. These ratings, which are
standard values for IDT commercially rated parts, are stress ratings only. Functional operation of the device at these
or any other conditions above those indicated in the operational sections of the specifications is not implied.
Exposure to absolute maximum rating conditions for extended periods can affect product reliability. Electrical
parameters are guaranteed only over the recommended operating temperature range.
Recommended Operation Conditions
Item Rating
Supply Voltage, VDD 7 V
All Inputs and Outputs -0.5 V to VDD+0.5 V
Ambient Operating Temperature (Commercial) 0 to +70° C
Ambient Operating Temperature (Industrial) -40 to +85° C
Storage Temperature -65 to +150° C
Junction Temperature 125° C
Soldering Temperature 260° C
Parameter Min. Typ. Max. Units
Ambient Operating Temperature 0 +70 ° C
Power Supply Voltage (measured in respect to GND) +3.0 +5.5 V

MK2745-24STR

Mfr. #:
Manufacturer:
Description:
IC CLK SOURCE DVD/MPEG 16-SOIC
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet