AP8802EV2
Issue 5 August 2009 www.diodes.com
© Diodes Incorporated 2009
4
R
1
AP8802
1
L
1
D
1
V
IN
SET
SW
GND
8V ~ 48V DC
Figure 2: Schematic of the Evaluation Board
R
2
C
1
C
3
CTRL
V
IN
GND
C
2
C
4
AP8802 OPERATION
In normal operation, when voltage is applied at V
IN
, the AP8802’s internal NDMOS switch is turned
on. Current starts to flow through sense resistor R1, inductor L1, and the LED(s). The current ramps
up linearly, the rate being determined by the input voltage V
IN
and inductor L1. This rising current
produces a voltage ramp across R1. The internal circuit of the AP8802 senses this voltage and
applies a proportional voltage to the input of the internal comparator. When this voltage reaches an
internally set upper threshold, the NDMOS switch is turned off. The inductor current continues to flow
through R1, L1, the LED(s), Schottky diode D1, and back to the supply rail. The current decays, with
the rate of decay determined by the forward voltage drop of the LEDs and the Schottky diode. This
decaying current produces a falling voltage at R1 which is sensed by the AP8802. A voltage
proportional to the sense voltage across R1 is applied at the input of the internal comparator. When
this voltage falls to the internally set lower threshold, the NDMOS switch is turned on again. This
switch-on-and-off cycle continues to provide an average current (set by the sense resistor R1) to the
LEDs. Please refer to the datasheet for the threshold limits, AP8802 internal circuits, electrical
characteristics and parameters.
AP8802EV2 EVALUATION BOARD - BILL OF MATERIALS
Ref Value Package Part Number Manufacturer Notes
U1 AP8802 SOP8LEP AP8802SPG DIODES inc DC-DC
converter
D1 100V, 2A SMB B2100 DIODES inc Schottky
diode
R1 0R2 1206 SR732ETTDR200F KOA +/-1
+/-100ppm
R2 0R0 0805 Generic - +/-1%
C1 4.7uF 50V 1210 C1210X475K5RAC
GRM32ER71H475KA88L
KEMET
Murata
X7R +/-10%
C2 - - Not Fitted
-
-
C3 100nF,100V 0805 Generic
-
X7R +/-20%
C4 100nF 100V 1206 Generic - X7R +/-20%
L1 68uH - MSS1038-683ML
NPIS104F680MTRF
NPIS24H680MTRF
Coilcraft
NIC
NIC
68uH
The FR4 PCB design, with adequate copper top and bottom and plated through vias for thermal
coupling, guarantees a good thermal dissipation for the AP8802 device. Other sources of heat are the
Schottky diode, the inductor and the sense resistor, therefore care must be taken in their placement.
Warning: At 45V operation with 1A output, the board temperature rises by around 60C from
ambient after 30 minutes of operation.