OMO ElectronicOMO Electronic
Expand menu
0 Cart

TS19705CX6 RFG

P1-P3P4-P6P7-P8
TS19705CX6
Taiwan Semiconductor
1 Version: C1607
Single Stage Flyback or Buck-Boost Current Control
with Active PFC for LED lighting
DESCRIPTION
TS19705 is constant current control IC with active
power factor correction isolated or non-isolated AC-DC
LED lighting control. The TS19705 is configurable as
an isolated, primary-side-regulated Flyback controller
or non-isolated Buck-Boost converter for LED lighting
applications. The IC achieves high power factor and
low Total Harmonic Distortion (THD) operation by
Boundary Conduction Mode (BCM). The line and load
regulation of LED current is about <±3% because of
particular control method. TS19705 also provides gate
driving voltage clamping, V
CC
overvoltage protection
and system output open/short circuit protection to
increase IC performance.
FEATURES
● Accuracy Constant Current <±3%
● Low BOM Cost
● Flyback or Buck-Boost w/o photocoupler
● Application Voltage Range: 90~264V
AC
● Built-in Active Power Factor Correction
● Good Line and Load Regulation
● Open-LED Protection on DMG pin
● Over-Voltage Protection on V
CC
pin
● Short-LED Protection
● Cycle by Cycle Over Current Protection on CS pin
● Over-Temperature Protection
● Gate Driving Voltage Clamping
A
PPLICATION
● LED lighting
● Down lights, Tube lamps, PAR Lamps, Bulbs
SO
T
-
Pin
Definition
:
1. COM
2. GND
3. CS
4. Output
5. V
CC
6. DMG
Notes: MSL 3 (Moisture Sensitivity Level) per J-STD-020
TYPICAL APPLICATOIN CIRCUIT
Flyback Converter
Buck
-
Boost Converter
TS19705CX6
Taiwan Semiconductor
2 Version: C1607
ABSOLUTE
M
AXIMUM RATINGS
(T
A
= 25°C unless otherwise specified)
(Note 1)
PARAMETER SYMBOL LIMIT UNIT
Power supply pin V
CC
40 V
DMG voltage to GND V
DMG
-0.3 to 40 V
OUT voltage to GND V
OUT
-0.3 to 40 V
CS voltage to GND V
CS
-0.3 to 5.5 V
COM voltage to GND V
COM
-0.3 to 5 V
Junction Temperature Range T
J
-40 to +150 °C
Storage Temperature Range T
STG
-65 to +150 °C
Power Dissipation @T
A
=25 °C P
D
0.3 W
ESD Rating (Human Body Model) ESD 2 kV
THERMAL PERFORMANCE
(Note 3)
PARAMETER SYMBOL LIMIT UNIT
Thermal Resistance - Junction to Case R
ӨJC
106
o
C/W
Thermal Resistance - Junction to Ambient R
ӨJA
220
o
C/W
RECOMMENDED OPERATING CONDITION
(T
A
= 25°C unless otherwise specified)
(Note 4)
PARAMETER SYMBOL LIMIT UNIT
Power supply pin V
CC
38 V
DMG voltage to GND V
DMG
-0.3 to 38 V
OUT voltage to GND V
OUT
-0.3 to 38 V
CS voltage to GND V
CS
-0.3 to 5 V
COM voltage to GND V
COM
-0.3 to V
CC
V
Operating Junction Temperature Range T
J
-40 to +125 °C
Operating Ambient Temperature Range T
OPA
-40 to +85 °C
ELECTRICAL SPECIFICATIONS
(T
A
= 25°C unless otherwise specified)
PARAMETER SYMBOL
CONDITION MIN
TYP
MAX
UNIT
Supply Voltage
Turn-on voltage V
CC_ON
17 18 19 V
Turn-off voltage V
CC_OFF
8.5 9.5 10 V
Quiescent current 1 I
Q1
V
CC
=17V, @ V
CC
off -- 30 50 µA
Quiescent current 2 I
Q2
Start-up @ 4.5kHz -- 600 800 µA
Operation supply current I
CC
-- 2.5 3..0 mA
Protection
V
CC
voltage protection V
OVPA
31 32 34 V
Output voltage protection V
OVPS
10 10.5 11 V
CS limit voltage V
OCP
1.15 1.25 1.35 V
Short circuit protection V
SCP
Guaranteed by design
-- 3 -- V
Oscillator
Start-up timer t
STR
-- 220 -- µs
TS19705CX6
Taiwan Semiconductor
3 Version: C1607
ELECTRICAL SPECIFICATIONS
(T
A
= 25°C unless otherwise specified)
PARAMETER SYMBOL
CONDITION MIN
TYP
MAX
UNIT
GM Amplifier
Transconductance g
m
-- 60 -- µA/V
Source current I
COMP_SOU
-- 20 -- µA
MOSFET Section
Dropout voltage
V
OH
V
CC
=33V, I
O
= 10mA -- 1.2 1.5 V
V
OL
V
CC
=33V, I
O
= -10mA -- 0.12 -- V
Rising time t
r
V
CC
=20V, C
O
=1nF -- 40 -- ns
Falling time t
f
V
CC
=20V, C
O
=1nF -- 80 -- ns
Output clamp voltage V
O_CLAMP
-- -- 19 V
Leading edge blanking time LEB
t
-- 0.5 -- µs
Note:
1. Stresses listed as the above “Absolute Maximum Ratings” may cause permanent damage to the device. These are for
stress ratings. Functional operation of the device at these or any other conditions beyond those indicated in the operational
sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may
remain possibility to affect device reliability.
2. Devices are ESD sensitive. Handing precaution recommended.
3. Thermal Resistance is specified with the component mounted on a low effective thermal conductivity test board in free air at
T
A
=25°C.
4. The device is not guaranteed to function outside its operating conditions.
5. Guaranteed by design.
6. Auto Recovery Type.
ORDERING INFORMATION
PART NO.
PACKAGE
PACKING
TS19705CX6 RFG SOT-26 3,000pcs / 7”Reel
P1-P3P4-P6P7-P8

TS19705CX6 RFG

Mfr. #:
Buy TS19705CX6 RFG
Manufacturer:
Taiwan Semiconductor
Description:
Supervisory Circuits LED Driver Single Stage PFC
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet