LA6585MC
www.onsemi.com
2
SPECIFICATIONS
ABSOLUTE MAXIMUM RATINGS (T
A
= 25°C)
Symbol
Parameter Conditions Ratings Unit
V
CC
max Supply Voltage 15 V
P
d
max Allowable Power Dissipation Mounted on a specified board (Note 1) 750 mW
I
OUT
max Output Current 0.7 A
V
OUT
max Output Withstand Voltage 15 V
V
RD/FG
max RD/FG Output Pin Output Withstand Voltage 15 V
I
RD/FG
max RD/FG Output Current 10 mA
I
B
max HB Output Current 10 mA
T
opr
Operating Temperature −30 to +90 °C
T
stg
Storage Temperature −55 to +150 °C
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality
should not be assumed, damage may occur and reliability may be affected.
1. Mounted on a specified board: 114.3 mm × 76.1 mm × 1.6 mm glass epoxy.
OPERATING CONDITIONS (T
A
= 25°C)
Symbol Parameter Conditions Ratings Unit
V
CC
Supply Voltage 2.2 to 14.0 V
V
I
CM Common-phase Input Voltage Range of
Hall Input
0 to V
CC
−1.5 V
Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond
the Recommended Operating Ranges limits may affect device reliability.
ELECTRICAL CHARACTERISTICS (T
A
= 25°C, V
CC
= 12 V, unless otherwise specified)
Symbol
Parameter Conditions Min Typ Max Unit
I
CC
1
Circuit Current
During drive (CT = L) 3 6 9 mA
I
CC
2 During lock protection (CT = H) 2.5 5 7.5 mA
I
CT
1 Lock Detection Capacitor Charge
Current
0.9 1.2 1.5
mA
I
CT
2 Capacitor Discharge Current 0.10 0.18 0.25
mA
R
CT
Capacitor Charge and Discharge
Current Ratio
RCD = I
CT
1/I
CT
2 5 6.5 8 −
V
CT
1 CT Charge Voltage 1.3 1.5 1.7 V
V
CT
2 CT Discharge Voltage 0.3 0.5 0.7 V
V
OL
OUT Output L Saturation Voltage
I
O
= 200mA
− 0.25 0.45 V
V
OH
OUT Output H Saturation Voltage
I
O
= 200mA
− 0.95 1.2 V
V
HN
Hall Input Sensitivity Zero peak value
(including offset and hysteresis)
− 7 15 mV
V
HB
Hall Bias Voltage I
HB
= 5 mA 1.3 1.5 1.7 V
V
FG/RD
FG/RD Output Pin L Voltage I
RD/FG
= 5 mA − 0.15 0.3 V
I
FG/RDL
FG/RD Output Pin Leak Current V
RD/FG
= 15 V − 1 30
mA
Product parametric performance is indicated in the Electrical Characteristics for the listed test conditions, unless otherwise noted. Product
performance may not be indicated by the Electrical Characteristics if operated under different conditions.