MAX5104
Low-Power, Dual, Voltage-Output, 12-Bit DAC
with Serial Interface
6 _______________________________________________________________________________________
_______________Detailed Description
The MAX5104 dual, 12-bit, voltage-output DAC is easily
configured with a 3-wire serial interface. The device
includes a 16-bit data-in/data-out shift register, and
each DAC has a double-buffered input composed of an
input register and a DAC register (see
Functional
Diagram
). In addition, trimmed internal resistors produce
an internal gain of +2V/V that maximizes output voltage
swing. The amplifier’s offset-adjust pin allows for a DC
shift in the DAC’s output.
Both DACs use an inverted R-2R ladder network that
produces a weighted voltage proportional to the input
voltage value. Each DAC has its own reference input to
facilitate independent full-scale values. Figure 1 depicts
a simplified circuit diagram of one of the two DACs.
Reference Inputs
The reference inputs accept both AC and DC values
with a voltage range extending from 0 to (V
DD
- 1.4V).
Determine the output voltage using the following equa-
tion (OS_ = AGND):
V
OUT
= (V
REF
· NB / 4096) · 2
where NB is the numeric value of the DAC’s binary input
code (0 to 4095) and V
REF
is the reference voltage.
The reference input impedance ranges from 14kΩ (1554
hex) to several gigohms (with an input code of 0000
hex). The reference input capacitance is code depen-
dent and typically ranges from 15pF with an input code
of all zeros to 50pF with a full-scale input code.
Output Amplifier
The MAX5104’s output amplifiers have internal resistors
that provide for a gain of +2V/V when OS_ is connected
to AGND. These resistors are trimmed to minimize gain
error. The output amplifiers have a typical slew rate of
0.75V/µs and settle to 1/2LSB within 15µs, with a load
of 10kΩ in parallel with 100pF. Loads less than 2kΩ
degrade performance.
The OS_ pin can be used to produce an adjustable off-
set voltage at the output. For instance, to achieve a 1V
offset, apply -1V to the OS_ pin to produce an output
range from 1V to (1V + V
REF
· 2). Note that the DAC’s
output range is still limited by the maximum output voltage
specification.
Power-Down Mode
The MAX5104 features a software-programmable shut-
down mode that reduces the typical supply current to
2µA. The two DACs can be powered down indepen-
dently, or simultaneously using the appropriate pro-
gramming command. Enter power-down mode by
writing the appropriate input-control word (Table 1). In
power-down mode, the reference inputs and amplifier
outputs become high impedance, and the serial inter-
face remains active. Data in the input registers is saved,
Digital GroundDGND9
Serial-Data OutputDOUT10
User-Programmable OutputUPO11
Power-Down Lockout. The device can-
not be powered down when PDL is low.
PDL
12
Reference for DAC BREFB13
Active-Low Clear Input. Resets all reg-
isters to zero. DAC outputs go to 0V.
CL
5
Chip-Select Input
CS
6
Serial-Data Input DIN7
Serial-Clock Input SCLK8
Reference for DAC A REFA4
DAC A Offset AdjustmentOSA3
PIN
DAC A Output Voltage OUTA2
Analog Ground AGND1
FUNCTIONNAME
14 OSB DAC B Offset Adjustment
15 OUTB DAC B Output Voltage
16 V
DD
Positive Power Supply