CS1W-FLN22

CSM_CS1W-FLN22_DS_E_1_2
1
SYSMAC CS-series FL-net Unit
CS1W-FLN22
Connect to Multivendor Controller
Networks
This Unit allows you to connect to FL-net, an open network based on
Ethernet. Multivendor FL-net networks can be built to combine CS-
series PLCs with CNC machines, robots, and PLCs from other
manufacturers.
Features
Conforms to FL-net, a quickly spreading standard.
FL-net is a multivendor FA network at the controller/machine level that is based on Ethernet. (It uses UDP/IP.)
FL-net supports message transmissions and cyclic data transmissions. (Message transmissions are also possible using FINS communications.)
A CS-series PLC can be used to interface communications between Ethernet information networks, OMRON's Controller Link FA network, and
DeviceNet field bus.
CS1W-FLN22
CS1W-FLN22
2
System Configuration
10BASE-T
100BASE-TX
Note: Do not combine nodes using a baud rate of 10 Mbps with nodes using a baud rate of 100 Mbps in the same configuration, where possible.
If nodes with a baud rate of 10 Mbps are used, use a baud rate of 10 Mbps for all the connected devices in the configuration.
About FL-net
FL-net is an open network that is based on Ethernet and that is being
promoted as a standard by the Special Committee for Network.
Promotion organized by JEMA (The Japan Electrical Manufacturers'
Association). FL-net enables multivendor, multi-model connections at
the controller/machine level. FL-net provides the following features.
z Ethernet-based FA Network
NL-net defines a new Ethernet-based FL link protocol.
The standard UDP/IP communications protocol of Ethernet is
used.
Cables, hubs, and other network components are easy to obtain.
z Message Transmissions and Cyclic Data Transmissions
Interlocks between devices, manufacturing instructions, collection
of manufacturing results can be achieved on the same network.
z Master-less, Token System
Prevents data collisions and provides consistent transmission
times.
Nodes can be automatically added to or removed from the
network.
Communications are maintained between all nodes that are
capable of communicating even if a power interruption occurs or a
fault occurs in network devices or cables.
Sensor
Actuator
Remote Terminal
50m max.
PLC
FL-net (Ver. 2.00) (10 Mbps)
500 m/segment max.
10Base-5 coaxial cable
(or 10Base-T twisted-pair cable)
Between nodes:
Integral multiples of 2.5 m
Terminator
Transceiver
FL-net Unit
CS1W-FLN22
Terminator
DeviceNet Unit
Other company's
FL-net (Ver. 2.0) node
10Base-T
FL-net Unit
CS1W-FLN22
PLC
Ground
Transceiver
cable
100m max.
Hub
DeviceNet
Other company's
FL-net (Ver. 2.0) node
10Base-T
Sensor ActuatorRemote Terminal
100m max.
PLC
FL-net Unit
CS1W-FLN22
DeviceNet Unit
Other company's
FL-net node
100Base-TX
CS1W-FLN22
FL-net Unit
PLC
Hub
DeviceNet
FL-net Unit
CS1W-FLN22
Hub
Hub
100m max.
100m max.
Twisted-pair
cable
CX-Programmer
3
CS1W-FLN22
Ordering Information
International Standards
The standards are abbreviated as follows: U: UL, U1: UL (Class I Division 2 Products for Hazardous Locations), C: CSA, UC: cULus, UC1: cULus (Class I Division
2 Products for Hazardous Locations), CU: cUL, N: NK, L: Lloyd, and CE: EC Directives.
Contact your OMRON representative for further details and applicable conditions for these standards.
FL-net Unit
Note: There is no accessory for the CS-series Ethernet Unit.
Recommended Network Devices
The following products are recommended for use with the FL-net Unit.
Mountable Racks
Unit
type
Product name
Specifications
No. of unit
numbers
allocated
Current
consumption (A)
Model Standards
Communications
interface
Communications
functions
Max. Units
mountable
per CPU
Units
5V 26V
CS1
CPU
Bus
Unit
FL-net Unit
100BASE-TX
With FL-net Ver. 2.0
specifications
(OPCN-2)
Data links and message
service
41 0.38CS1W-FLN22 UC1, CE
Part Maker Model number Specification
Twisted-pair cable
100BASE-TX
Fujikura F-LINE-E 0.5mm × 4P
STP (shielded twisted-pair) cable: Category 5,5e
Note: Impedance is limited 100 .
Fujikura CTP-LAN5 0.5mm × 4P UTP (unshielded twisted-pair) cable: Category 5,5e
100BASE-TX
Fujikura F-LINE-E 0.5mm × 4P
STP (shielded twisted-pair) cable: Category 3,4,5,5e
Note: Impedance is limited 100 .
Fujikura CTP-LAN5 0.5mm × 4P UTP (unshielded twisted-pair) cable: Category 3,4,5,5e
Connector
(Modular plug)
STP Plug
Panduit Corp MPS588
UTP Plug
Panduit Corp MP588-C
Model
CS1 System CS1D System
CPU Rack
Expansion
Backplane (including
Longdistance
Expansion Rack)
SYSBUS
Remote
I/O Slave
Rack
C200HX/
HG/HE
Expansion
I/O Rack
CPU Rack
Expansion
Backplane
CS1W-BC CS1W-BI CS1D-BC CS1D-BI
@@3 @@2 @@3 @@2 052 042D 082S 092 082D
CS1W-FLN22 4 Units (per CPU Unit)
Not
supported
Not
supported
4 Units (per CPU Unit)

CS1W-FLN22

Mfr. #:
Manufacturer:
Omron Automation and Safety
Description:
Controllers CS1 FLNet module
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet