MAX4717/MAX4718
4.5
Ω
/20
Ω
, 300MHz Bandwidth, Dual SPDT
Analog Switches in UCSP
6 _______________________________________________________________________________________
Note 2: UCSP and TDFN parts are 100% tested at +25°C only, and guaranteed by design over the specified temperature range.
µMAX parts are 100% tested at T
MAX
and guaranteed by design over the specified temperature range.
Note 3: The algebraic convention used in this data sheet is where the most negative value is a minimum and the most positive
value is a maximum.
Note 4: Guaranteed by design for UCSP and TDFN parts.
Note 5: ∆R
ON
= R
ON(MAX)
- R
ON(MIN)
.
Note 6: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the
specified analog signal ranges.
Note 7: Guaranteed by design.
Note 8: Between any two switches.
ELECTRICAL CHARACTERISTICS—Single +5V Supply (continued)
(V+ = +4.2V to +5.5V, V
IH
= +2.0V, V
IL
= +0.8V, T
A
= T
MIN
to T
MAX
, unless otherwise noted. Typical values are at V+ = +5.0V,
T
A
= +25°C, unless otherwise noted.) (Notes 2, 3)
ON-RESISTANCE vs. COM_ VOLTAGE
ON-RESISTANCE vs. COM_ VOLTAGE
ON-RESISTANCE vs. COM_ VOLTAGE
Typical Operating Characteristics
(T
A
= +25°C, unless otherwise noted.)