© 2006 Microchip Technology Inc. DS21394C-page 3
TC14433/A
1.0 ELECTRICAL
CHARACTERISTICS
Absolute Maximum Ratings*
Supply Voltage (V
DD
– V
EE
)................... -0.5V to +18V
Voltage on Any Pin:
Reference to V
EE
.....................-0.5V to (V
DD
+ 0.5)
DC Current, Any Pin: .......................................±10 mA
Power Dissipation (T
A
≤ 70°C):
Plastic PLCC .................................................1.0W
Plastic PDIP..................................................940W
SOIC.............................................................940W
CERDIP.......................................................1.45W
Operating Temperature Range ...............0°C to +70°C
Storage Temperature Range..............-65°C to +160°C
*Stresses above those listed under “Absolute
Maximum Ratings” may cause permanent damage to
the device. These are stress ratings only and functional
operation of the device at these or any other conditions
above those indicated in the operation sections of the
specifications is not implied. Exposure to Absolute
Maximum Rating conditions for extended periods may
affect device reliability.
TABLE 1-1: TC14433/A ELECTRICAL SPECIFICATIONS
Electrical Characteristics: V
DD
= +5V, V
EE
= -5V, C
1
= 0.1 μF, (Mylar), C
0
= 0.1 μF, R
C
= 300 kΩ, R
1
= 470 kΩ @ V
REF
= 2V, R
1
=
27 kΩ @ V
REF
= 200 mV, T
A
= 25°C, unless otherwise specified.
Symbol Parameter
Min Typ Max Min Typ Max Units Test Conditions
Analog Input
SYE Rollover Error (Positive) and
Negative Full Scale
Symmetry
-1 — +1 — — — Count
s
200 mV Full Scale
V
IN
-V
IN
= +V
IN
NL Linearity Output Reading
(Note 1)
-0.05 +0.05 +0.05 — — — %rdg V
REF
= 2V
-1 count — +1 count — — — %rdg V
REF
= 200 mV
SOR Stability Output Reading
(Note 2)
—— 2 ———LSDV
X
= 1.99V,
V
REF
= 2V
—— 3 ———LSDV
X
= 199 mV,
V
REF
= 200 mV
ZOR Zero Output Reading
—0 0——— LSDV
X
= 0V, V
REF
= 2V
I
IN
Bias Current: Analog Input
Reference Input
Analog Ground
—±20±100———pA
—±20±100———pA
—±20±100———pA
CMRR Common mode Rejection
—65—— —— dBV
X
= 1.4V, V
REF
= 2V,
F
OC
= 32 kHz
Note 1: Accuracy – The accuracy of the meter at full scale is the accuracy of the setting of the reference voltage. Zero is
recalculated during each conversion cycle. The meaningful specification is linearity. In other words, the deviation from
correct reading for all inputs other than positive full scale and zero is defined as the linearity specification.
2: The LSD stability for 200 mV scale is defined as the range that the LSD will occupy 95% of the time.
3: Pin numbers refer to 24-pin PDIP.
