MAX1630A–MAX1635A
Multi-Output, Low-Noise Power-Supply
Controllers for Notebook Computers
4 _______________________________________________________________________________________
Note 1: Each of the four digital soft-start levels is tested for functionality; the steps are typically in 20mV increments.
Note 2: High duty-factor operation supports low input-to-output differential voltages, and is achieved at a lowered operating
frequency (see Overload and Dropout Operation section).
Note 3: MAX1630A/MAX1632A/MAX1633A/MAX1635A only.
Note 4: Off mode for the 12V linear regulator occurs when the SMPS that has flyback feedback (V
DD
) steered to it is disabled. In
situations where the main outputs are being held up by external keep-alive supplies, turning off the 12OUT regulator pre-
vents a leakage path from the output-referred flyback winding, through the rectifier, and into V
DD
.
Note 5: Since the reference uses VL as its supply, the reference’s V+ line-regulation error is insignificant.
ELECTRICAL CHARACTERISTICS (continued)
(V+ = 15V, both PWMs on, SYNC = VL, VL load = 0mA, REF load = 0mA, SKIP = 0V, T
A
= T
MIN
to T
MAX
, unless otherwise noted.
Typical values are at T
A
= +25°C.)
Typical hysteresis = +10°C
From each SMPS enabled, with respect to f
OSC
°C150
Clks5000 6144 7000
With respect to unloaded output voltage
Output Undervoltage Lockout Time
Thermal Shutdown Threshold
With respect to f
OSC
Falling edge, CSL_ driven 2%
below RESET trip threshold
Clks27,000 32,000 37,000
µs1.5
With respect to unloaded output voltage,
falling edge; typical hysteresis = 1%
RESET Propagation Delay
RESET Delay Time
%-7 -5.5 -4
CONDITIONS
RESET Trip Threshold
RESET, I
SINK
= 4mA
RUN/ON3, SKIP, TIME/ON5 (SEQ = REF),
SHDN, STEER, SYNC, SEQ; V
PIN
= 0V or 3.3V
V0.4
µA±1Input Leakage Current
Logic Output Low Voltage
CSL_ driven 2% above overvoltage trip threshold µs
FB3, FB5; SECFB = 2.6V
1.5Overvoltage-Fault Propagation Delay
nA150
With respect to unloaded output voltage %60 70 80
Feedback Input Leakage Current
Output Undervoltage Threshold
%4710Overvoltage Trip Threshold
RUN/ON3, SKIP, TIME/ON5 (SEQ = REF),
SHDN, STEER, SYNC
RUN/ON3, SKIP, TIME/ON5 (SEQ = REF),
SHDN, STEER, SYNC
V2.4
V0.6Logic Input Low Voltage
Logic Input High Voltage
UNITSMIN TYP MAXPARAMETER
High or low
DL3, DH3, DL5, DH5; forced to 2V
Ω1.5 7
A1Gate Driver Sink/Source Current
Gate Driver On-Resistance
RESET = 3.5V
mA1Logic Output High Current
TIME/ON5 = 0V, SEQ = 0V or VL
SEQ = 0V or VL
µA2.5 3 3.5
V2.4 2.6TIME/ON5 Input Trip Level
TIME/ON5 Source Current
TIME/ON5; RUN/ON3 = 0V, SEQ = 0V or VL Ω15 80TIME/ON5 On-Resistance
FAULT DETECTION (MAX1630A/MAX1631A/MAX1632A)
INPUTS AND OUTPUTS
RESET
