1
INDUSTRIAL TEMPERATURE RANGE
IDT5T9821
EEPROM PROGRAMMABLE 2.5V ZERO DELAY PLL DIFFERENTIAL CLOCK DRIVER
NOVEMBER 2004
2004 Integrated Device Technology, Inc. DSC - 6502/20c
INDUSTRIAL TEMPERATURE RANGE
The IDT logo is a registered trademark of Integrated Device Technology, Inc.
FEATURES:
• 2.5 VDD
• 6 pairs of outputs
• Low skew: 100ps all outputs at same interface level, 250ps all
outputs at different interface levels
• Selectable positive or negative edge synchronization
• Tolerant of spread spectrum input clock
• Synchronous output enable
• Selectable inputs
• Input frequency: 4.17MHz to 250MHz
• Output frequency: 12.5MHz to 250MHz
• Internal non-volatile EEPROM
• JTAG or I
2
C bus serial interface for programming
• Hot insertable and over-voltage tolerant inputs
• Feedback divide selection with multiply ratios of (1-6, 8, 10, 12)
• Selectable HSTL, eHSTL, 1.8V/2.5V LVTTL, or LVEPECL input
interface
• Selectable HSTL, eHSTL, or 1.8V/2.5V LVTTL output interface for
each output bank
• Selectable differential or single-ended inputs and six differen-
tial outputs
• PLL bypass for DC testing
• External differential feedback, internal loop filter
• Low Jitter: <75ps cycle-to-cycle, all outputs at same interface
level: <100ps cycle-to-cycle all outputs at different interface
levels
• Power-down mode
• Lock indicator
• Available in VFQFPN package
IDT5T9821
EEPROM PROGRAMMABLE 2.5V
ZERO DELAY PLL DIFFERENTIAL
CLOCK DRIVER
DESCRIPTION:
The IDT5T9821 is a 2.5V PLL differential clock driver intended for high
performance computing and data-communications applications. The
IDT5T9821 has six differential outputs in six banks, including a dedicated
differential feedback. The redundant input capability allows for a smooth
change over to a secondary clock source when the primary clock source
is absent.
The clock driver can be configured through the use of JTAG/I
2
C program-
ming. An internal EEPROM will allow the user to save and restore the
configuration of the device.
The feedback bank allows divide-by-functionality from 1 to 12 through
the use of JTAG or I
2
C programming. This provides the user with frequency
multiplication 1 to 12 without using divided outputs for feedback. Each output
bank also allows for a divide-by functionality of 2 or 4.
The IDT5T9821 features a user-selectable, single-ended or differential
input to six differential outputs. The differential clock driver also acts as a
translator from a differential HSTL, eHSTL, 1.8V/2.5V LVTTL, LVEPECL, or
single-ended 1.8V/2.5V LVTTL input to HSTL, eHSTL, or 1.8V/2.5V LVTTL
outputs. Each output bank can be individually configured to be either HSTL,
eHSTL, 2.5V LVTTL, or 1.8V LVTTL, including the feedback bank. Also, each
clock input can be individually configured to accept 2.5V LVTTL, 1.8V LVTTL,
or differential signals. The outputs can be synchronously enabled/disabled.
The differential outputs can be synchronously enabled/disabled.
Furthermore, all the outputs can be synchronized with the positive edge
of the REF clock input. or the negative edge of REF.