ADG5204
Rev. 0 | Page 16 of 20
TERMINOLOGY
I
DD
The positive supply current.
I
SS
The negative supply current.
V
D
, V
S
The analog voltage on Terminal D and Terminal S.
R
ON
The ohmic resistance between Terminal D and Terminal S.
R
FLAT(ON)
Flatness that is defined as the difference between the maximum
and minimum value of on resistance measured over the specified
analog signal range.
I
S
(Off)
The source leakage current with the switch off.
I
D
(Off)
The drain leakage current with the switch off.
I
D
, I
S
(On)
The channel leakage current with the switch on.
V
INL
The maximum input voltage for Logic 0.
V
INH
The minimum input voltage for Logic 1.
I
INL
, I
INH
The input current of the digital input.
C
S
(Off)
The off switch source capacitance, which is measured with
reference to ground.
C
D
(Off)
The off switch drain capacitance, which is measured with
reference to ground.
C
D
(On), C
S
(On)
The on switch capacitance, which is measured with reference to
ground.
C
IN
The digital input capacitance.
t
TRANSITION
The delay time between the 50% and 90% points of the digital
input and switch-on condition when switching from one address
state to another.
t
ON
(EN)
The delay between applying the digital control input and the
output switching on. See Figure 31.
t
OFF
(EN)
The delay between applying the digital control input and the
output switching off. See Figure 31.
Charge Injection
A measure of the glitch impulse transferred from the digital
input to the analog output during switching.
Off Isolation
A measure of unwanted signal coupling through an off switch.
Crosstalk
A measure of unwanted signal that is coupled through from one
channel to another as a result of parasitic capacitance.
Bandwidth
The frequency at which the output is attenuated by 3 dB.
On Response
The frequency response of the on switch.
Insertion Loss
The loss due to the on resistance of the switch.
ACPSRR (AC Power Supply Rejection Ratio)
The ratio of the amplitude of signal on the output to the amplitude
of the modulation. This is a measure of the ability of the device
to avoid coupling noise and spurious signals that appear on the
supply voltage pins to the output of the switch. The dc voltage on
the device is modulated by a sine wave of 0.62 V p-p.
