STDE-B-XH0414H02RII06E-0010-1
P.11/12
10. Inspection (Outgoing and Incoming)
10-1. Lot composition
Lot must be composed within the same manufacturing conditions.
10-2. Outgoing Inspection
SII Micro Parts Ltd., shall do outgoing inspection before shipping. The inspection items
are as below table. The inspection results shall be submitted immediately for the
customer request.
No Characteristics Inspection levels Frequency
1 Capacity (initial) n=6, c=0 per lot
2 Internal Impedance (initial) n=6, c=0 per lot
3 Leakage Resistance n=10, c=0 per lot
10-3. Incoming Inspection
The customer should do incoming inspection within 30 days from the receiving day.
If defects are find out at the incoming inspection, the customer immediately should
notify to SII Micro Parts Ltd. in writing, with the defective products, for replacement
request. When there was no connection from you within 30 days, we shall judge that
those were accepted.
11. Package specifications
Examples of the tray etc. for wrapping, wrapping specification, and packing
specification are shown in the following.
11-1. Wrapping
Refer to “Drawing of Emboss Carrier Tape” and “Taping specifications”.
11-2. Wrapping and packing
Refer to “Package Specifications”.
12. In case of quality trouble
The warranties set forth herein are the only warranties on the Products.
The liabilities of SII Micro Parts Ltd. in connection with the Products under these
specifications are expressly limited to the replacement of defective Products.
13. Operation of this Specification
13-1. Agreement
Before these specifications being revised, the agreement, of the customer, seller and
manufacturer, is required.
13-2. Negotiation
If some accident not specified on these specifications occurs, the customer, seller
and manufacturer must negotiate in order to solve the problem faithfully.