F3M-S825-1
F3M-S825-1
4
mens
ons
Unit: mm (inch)
J
F3M-S825-1
Optical axis
Side mark
Thirty, (19/0.08 dia.)
vinyl-insulated,
flat bending cable
500 L x 38.1 W
Pitch: 1.27
Two,
4.2-dia.
mounting
holes
OMRON XG4E-3031
Connector
Teaching button
RUN/TEACH mode selector
Warning indicator
Teaching indicator
Power indicator
Mounting Dimensions
Two, R5
Two, M4
50
(1.97)
18.5 (0.71)
170 (6.69)
14 (0.55)
(3.94)
(6.30)
18.5 (0.71)
recaut
ons
J
CORRECT USE—T O AVOID DAMAGE
x
Do not use the F3M-S825-1 at a voltage that exceeds the
rated voltage range.
x
Do not make mistakes in wiring, such as mistakes in polarity.
x
Do not short-circuit the load.
x
Do not connect AC to the F3M-S825-1
.
J
INSTALLATION/ENVIRONMENT
Do NOT use the F3M-S825-1 in the following locations:
x
Locations exposed to direct sunlight.
x
Locations with high humidity that may cause condensation.
x
Locations with corrosive gas.
x
Locations where vibration or shock directly affects the
Sensor.
J
CLEANING
Do not attempt to clean the F3M-S825-1 using paint thinner, to
avoid damaging the surface of the Sensor.
J
CONNECTION AND MOUNTING
x
A maximum of 24 VDC+10% can be imposed on the
F3M-S825-1. Check that the voltage of the power supply is
within the permissible range before turning on the
F3M-S825-1. The power supply must be constructed so that
the secondary circuit is insulated with an isolating
transformer.
x
Do not wire power lines or high-voltage lines within the
same conduit with the lines of the F3M-S825-1, or the sensor
may be damaged or malfunction.
x
Avoid mechanical impact when mounting the F3M-S825-1, or
its water-resistant properties will be reduced.
J
POWER SUPPLY
If a standard switching power supply is connected to the
F3M-S825-1, be sure to ground the FG (frame ground) and
G (ground) terminals of the power supply . If these terminals are
not grounded, the Sensor may malfunction due to switching noise
that will be generated from the power supply.
Cat. No. D063-E3-825 7/00 Specifications subject to change without notice. Printed in U.S.A.
OMRON ELECTRONICS, INC.
One East Commerce Drive
Schaumburg, IL 60173
NOTE: DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters to inches divide by 25.4.
1-800-55-OMRON
OMRON CANADA, INC.
885 Milner Avenue
Scarborough, Ontario M1B 5V8
416-286-6465
R
