FLM DI 8 M12
6 697000
Connection Example
Figure 9 Typical connection of sensors
Connection Notes
6 9 7 0 A 0 0 5
I 1
I 2
I N 2
+ 2 4 V
I N 1
+ 2 4 V
Meet noise immunity requirements
Connect FE using a mounting screw
or a cable connection to the FE
connection latch (when mounting on
a non-conductive surface).
Ensure degree of protection
To ensure IP65/IP67 protection,
cover unused sockets with protective
caps.
Avoid damage to the electronics
Make sure you only supply the
sensors with the voltage U
S
provided
at the connection points.
Avoid polarity reversal
Avoid polarity reversal of the supply
voltages U
L
and U
S
in order to
prevent damage to the device.
Observe connection point
assignment
When connecting the sensors,
observe the assignment of the
connection points to the IN
process data (see "Process Data" on
page 7).