Features
Integrated PLL Loop Filter
ESD Protection also at ANT1/ANT2
(4 kV HBM/200 V MM; Except Pin 2: 4 kV HBM/100 V MM)
High Output Power (8.0 dBm) with Low Supply Current (9.0 mA)
Modulation Scheme ASK/FSK
FSK Modulation is Achieved by Connecting an Additional Capacitor Between the
XTAL Load Capacitor and the Open Drain Output of the Modulating Microcontroller
Easy to Design-in Due to Excellent Isolation of the PLL from the PA and Power Supply
Single Li-cell for Power Supply
Supply Voltage 2.0V to 4.0V in the Temperature Range of –40°C to +85°C/125°C
Package TSSOP8L
Single-ended Antenna Output with High Efficient Power Amplifier
CLK Output for Clocking the Microcontroller
One-chip Solution with Minimum External Circuitry
125°C Operation for Tire Pressure Systems
1. Description
The T5753 is a PLL transmitter IC which has been developed for the demands of RF
low-cost transmission systems at data rates up to 32 kBaud. The transmitting
frequency range is 310 MHz to 350 MHz. It can be used in both FSK and ASK
systems.
Figure 1-1. System Block Diagram
Micro-
controller
PLL
UHF ASK/FSK
Remote control receiver
UHF ASK/FSK
Remote control transmitter
T5753 U3741B/
U3745B/
T5743/
T5744
LNA VCO
PLL XTO
LNA
VCO
Antenna
Demod
IF Amp
Control
1 to 3
Encoder
ATARx9x
XTO
1 Li cell
Keys
Antenna
UHF ASK/FSK
Transmitter
T5753
4510J–RKE–12/08
2
4510J–RKE–12/08
T5753
2. Pin Configuration
Figure 2-1. Pinning TSSOP8L
ENABLE
3
4
2
1
VS
GND
T5753
XTAL
CLK
PA_ENABLE
8
7
6
5
ANT2
ANT1
Table 2-1. Pin Description
Pin Symbol Function Configuration
1CLK
Clock output signal for microcontroller
The clock output frequency is set by the
crystal to f
XTAL
/4
2 PA_ENABLE
Switches on power amplifier, used for
ASK modulation
3
4
ANT2
ANT1
Emitter of antenna output stage
Open collector antenna output
100Ω
100Ω
CLK
VS
50 k
Ω
20 µA
U
REF
= 1.1V PA_ENABLE
ANT1
ANT2
3
4510J–RKE–12/08
T5753
Figure 2-2. Block Diagram
5 XTAL Connection for crystal
6 VS Supply voltage See ESD protection circuitry (see Figure 4-5 on page 9)
7 GND Ground See ESD protection circuitry (see Figure 4-5 on page 9)
8 ENABLE Enable input
Table 2-1. Pin Description (Continued)
Pin Symbol Function Configuration
1.5 kΩ 1.2 kΩ
182 µA
XTAL
VS
VS
200 kΩ
ENABLE
T5753
CP
Power up/down
PDF
32
5
6
7
8
4
3
2
XTAL
VS
GND
ENABLE
ANT1
ANT2
PA_ENABLE
CLK
1
f
LF
PA VCO
PLL
XTO
4
f

T5753-6AP

Mfr. #:
Manufacturer:
Description:
RF TX IC ASK 310-350MHZ 8TSSOP
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet