REV. 0–4–
AD9860/AD9862
Test AD9860/AD9862
(20 pF Load) Temp Level Min Typ Max Unit
Minimum Reset Pulsewidth Low (t
RL
)NANA5 Clock
Cycles
Digital Output Rise/Fall Time 25ºC III 2.8 4 ns
DLL Output Clock 25ºC III 32 128 MHz
DLL Output Duty Cycle 25ºC III 50 %
Tx–/Rx–Interface (See Figures 11 and 12)
TxSYNC/TxIQ Setup Time (t
Tx1
, t
Tx3
)25ºC III 3 ns
TxSYNC/TxIQ Hold Time (t
Tx2
, t
Tx4
)25ºC III 3 ns
RxSYNC/RxIQ/IF to Valid Time(t
Rx1
, t
Rx3
)25ºC III 5.2 ns
RxSYNC/RxIQ/IF Hold Time (t
Rx2
, t
Rx4
)25ºC III 0.2 ns
Serial Control Bus (See Figures 1 and 2)
Maximum SCLK Frequency (f
SCLK
) Full III 16 MHz
Minimum Clock Pulsewidth High (t
HI
) Full III 30 ns
Minimum Clock Pulsewidth Low (t
LOW
) Full III 30 ns
Maximum Clock Rise/Fall Time Full III 1 ms
Minimum Data/SEN Setup Time (t
S
) Full III 25 ns
Minimum SEN/Data Hold Time (t
H
) Full III 0 ns
Minimum Data/SCLK Setup Time (t
DS
) Full III 25 ns
Minimum Data Hold Time (t
DH
) Full III 0 ns
Output Data Valid/SCLK Time (t
DV
) Full III 30 ns
AUXILARY ADC
Conversion Rate 25ºC III 1.25 MHz
Input Range 25ºC III 3 V
Resolution 25ºC III 10 Bits
AUXILARY DAC
Settling Time 25ºC III 8 ms
Output Range 25ºC III 3 V
Resolution 25ºC III 8 Bits
ADC TIMING
Latency (All Digital Processing Blocks Disabled) 25ºC III 7 Cycles
DAC Timing
Latency (All Digital Processing Blocks Disabled) 25ºC III 3 Cycles
Latency (2 Interpolation Enabled) 25ºC III 30 Cycles
Latency (4 Interpolation Enabled) 25ºC III 72 Cycles
Additional Latency (Hilbert Filter Enabled) 25ºC III 36 Cycles
Additional Latency (Coarse Modulation Enabled) 25ºC III 5 Cycles
Additional Latency (Fine Modulation Enabled) 25ºC III 8 Cycles
Output Settling Time (TST) (to 0.1%) 25ºC III 35 ns
Specifications subject to change without notice.
TIMING CHARACTERISTICS
Test AD9860/AD9862
PARAMETERS (continued) Temp Level Min Typ Max Unit
POWER SUPPLY (continued)
Rx Path (f
ADC
= 64 MSPS)
Processing Blocks Disabled 25ºC III 9 mA
Decimation Filter Enabled 25ºC III 15 mA
Hilbert Filter Enabled 25ºC III 16 mA
Hilbert and Decimation Filter Enabled 25ºC III 18.5 mA
NOTES
1
% f
DATA
refers to the input data rate of the digital block.
2
Interpolation filter stop band is defined by image suppression of 50 dB or greater.
Specifications subject to change without notice.