CAUTION: The small device geometries inherent to the design of this bipolar component increase the component’s
susceptibility to damage from electrostatic discharge (ESD). It is advised that normal static precautions be taken in
handling and assembly of this component to prevent damage and/or degradation which may be induced by ESD.
Description
These small outline, low input current, high gain
optocouplers are single channel devices in a five lead
miniature footprint. They are electrically equivalent
to the following Avago optocouplers:
The SO-5 JEDEC registered (MO-155) package outline
does not require “through holes” in a PCB. This
package occupies approximately one-fourth the
footprint area of the standard dual-in-line package.
The lead profile is designed to be compatible with
standard surface mount processes.
These high gain series opto-couplers use a Light
Emitting Diode and an integrated high gain photo-
detector to provide extremely high current transfer
ratio between input and output. Separate pins for
the photodiode and output stage results in TTL
compatible saturation voltages and high speed
operation. Where desired the V
CC
and V
O
terminals
may be tied together to achieve conventional photo-
darlington operation.
The HCPL-M701 is for use in CMOS, LSTTL or other
low power applications. A 400% minimum current
transfer ratio is guaranteed over a 0-70°C operating
range for only 0.5 mA of LED current.
The HCPL-M700 is designed for use mainly in TTL
applications. Current Transfer Ratio is 300%
minimum over 0-70°C for an LED current of 1.6 mA
[1 TTL Unit Load (U.L.)]. A 300% CTR enables operation
with 1 U.L. out with a 2.2 kΩ pull-up resistor.
Selection for lower input currents down to 250 µA is
available upon request.
Features
• Surface mountable
• Very small, low profile JEDEC registered package outline
• Compatible with infrared vapor phase reflow and wave
soldering processes
• High current transfer ratio: 2000%
• Low input current capability: 0.5 mA
• TTL compatible output: V
OL
= 0.1 V
• Guaranteed ac and dc performance over temperature:
0°C to 70°C
• High output current: 60 mA
• Recognized under the component program of U.L. (file No.
E55361) for dielectric withstand proof test voltage of 3750
Vac, 1 minute
• Lead free option “-000E”
Applications
• Ground isolate most logic families: TTL/TTL, CMOS/TTL,
CMOS/CMOS, LSTTL/TTL, CMOS/LSTTL
• Low input current line receiver
• EIA RS232C line receiver
• Telephone ring detector
• ac line voltage status indicator:
low input power dissipation
• Low power systems: ground isolation
HCPL-M700/HCPL-M701
Small Outline, 5 Lead, Low Input Current, High Gain Optocouplers
Data Sheet
SO-5 Package Standard DIP SO-8 Package
HCPL-M700 6N138 HCPL-0700
HCPL-M701 6N139 HCPL-0701
