Spec No. JEFL243C-9116D-01 P2/10
MURATA MFG.CO.,LTD
Reference Only
7. Electrical Performance
No. Item Specification Test Method
7.1 Common Mode
Impedance
Meet item 3. Measuring Frequency : 100±1MHz (ref.item 9.)
Measuring Equipment : KEYSIGHT 4991A or the
equivalents
(In case of doubt in standard condition, the heat
treatment (200°C,about 10 minutes)shall be applied.
7.2 Withstanding
Voltage
Products shall not be damaged. Test Voltage : 2.5 times for Rated Voltage
Time : 1 to 5 seconds
Charge Current : 1 mA max.(ref.item 9.)
7.3 DC Resistance
(Rdc)
Meet item 3. Measuring current : 10mA max.(ref.item 9.)
7.4 Insulation
Resistance (I.R.)
Measuring voltage : Rated Voltage
Measuring time : 1 minute max. (ref.item 9.)
8. Q200 Requirement
8-1. Performance (based on Table 13 for Ferrite EMI SUPPRESSORS/FILTERS)
AEC-Q200 Rev.D issued June 1. 2010
AEC-Q200
Murata Specification / Deviation
No.
Stress Test Method
3
High
Temperature
Exposure
1000hours at 125 deg C
Set for 24hours at room
temperature, then measured.
Meet Table A after testing.
Table A
4
Temperature Cycling 1000cycles
-55 deg C to +125 deg C
Set for 24hours at room
temperature, then measured.
Meet Table A after testing.
5
Destructive
Physical Analysis
Per EIA469
No electrical tests
No defects
7
Biased Humidity 1000hours at 85 deg C,
85%RH
Apply max rated current.
Meet Table A after testing.
(ref.item 9)
8
Operational Life Apply 125 deg C
1000hours
Set for 24hours at room
temperature, then measured
Meet Table A after testing.
Apply rated current.
(ref.item 9)
9
External Visual Visual inspection No abnormalities
10 Physical Dimension Meet ITEM 4
（Style and Dimensions）
No defects
12 Resistance to Solvents Per MIL-STD-202 Method 215 Not Applicable
13 Mechanical Shock Per MIL-STD-202 Method 213
Condition F:
1500g’s(14.7N)/0.5ms/
Half sine
Meet Table A after testing.
Appearance
No damaged
Common Mode
Impedance
Change
within ±20%
Rdc change
within ±30%
I.R.
100MΩ min.
Withstanding
Voltage
No damaged
