Spec No. JEFL243B-9101F-01 P3/10
MURATA MFG.CO.,LTD
Reference Only
6. Electrical Performance
No. Item Specification Test method
6.1 Common
Mode
Impedance
(Zc) Typ.
Meet item 3 Measuring Frequenc
: 10MHz (ref.item 8)
Measuring Equipment: KEYSIGHT 4192A or the equivalent
Use a cable / connector of 50Ω impedance.
6.2 Withstand
Voltage
Products shall not be damaged. Voltage: Rated Voltage×250% (ref.item 8)
Time:1~5s
Measuring current: 10mA max.
6.3 Insulation
Resistance
(I.R.)
Meet item 3 Voltage: Rated Voltage (ref.item 8)
Time: 30s max.
Measuring current: 10mA max
Measuring Equipment: KEYSIGHT 4339A or the equivalent
6.4 DC
Resistance
(Rdc)
Meet item 3 Measuring method: fou
-terminal method (ref.item 8)
6.5 Inductance
(L)
Meet item 3 Measuring Frequenc
:1±0.1kHz (ref.item 8)
Voltage: 1V (rms) max.
Measuring Equipment: KEYSIGHT 4278A or the equivalent
7.Q200 Requirement
7-1. Performance (based on Table 13 for Ferrite EMI SUPPRESSORS/FILTERS)
AEC-Q200 Rev.D issued June 1. 2010
AEC-Q200
Murata Specification / Deviation
No. Stress Test Method
3 High Temperature
Exposure
1000hours at Maximum
Operating Temperature Set
for 24hours at room
temperature, then measured.
Meet Table A after testing.
Table A
4 Temperature Cycling 1000cycles
-55 deg C to + Maximum
Operating Temperature
Set for 24hours at room
temperature, then measured.
Meet Table A after testing.
5 Destructive
Physical Analysis
Per EIA469
No electrical tests
Not Applicable
7 Biased Humidity 1000hours at 85 deg C,
85%RH
Apply max rated voltage.
Meet Table A after testing.
(ref.item 8.2)
8 Operational Life Apply Maximum Operating
Temperature 1000hours
Set for 24hours at room
temperature, then measured.
Meet Table A after testing.
Apply rated voltage.
(ref.item 8.2)
9 External Visual Visual inspection No abnormalities
10 Physical Dimension Meet ITEM 4
(Style and Dimensions)
No defects
12 Resistance to Solvents Per MIL-STD-202 Method
215
Not Applicable
13 Mechanical Shock Per MIL-STD-202 Method
213
Condition F:
1500g’s(14.7N)/0.5ms/
Half sine
Meet Table A after testing.
Appearance No damage
Inductance
change
(%∆L)
within ±15%
Insulation
Resistance
(I.R.)
Meet item 3
Withstand
Voltage
Products shall not
be damaged.