Spec No. JEFL243B-9101F-01 P4/10
MURATA MFG.CO.,LTD
Reference Only
AEC-Q200
Murata Specification / Deviation
No
Stress Test Method
14 Vibration 5g's(0.049N) for 20 minutes,
12cycles each of 3 oritentations
Test from 10-2000Hz.
12cycles each of 3 orientations
Meet Table A after testing.
15 Resistance
to Soldering Heat
No-heating
Solder temperature
260C+/-5 deg C
Immersion time 10s
Pre-heating：150 to 180C / 90±30s
Meet Table A after testing.
17 ESD
Per AEC-Q200-002 Meet Table A after testing.
ESD Rank: Refer to Item 3. Rating.
18 Solderbility
Per J-STD-002 Method b : Not Applicable
95% of the terminations is to be soldered.(except partly-exposed wire)
Flux:Ethanol solution of rosin,25(wt)% includes activator equivalent to
0.06 to 0.10(wt)% chlorine
19 Electrical
Characterization
Measured : Inductance Refer to 3.Rating.
20 Flammability Per UL-94 Not Applicable
21 Board Flex Epoxy-PCB(1.6mm)
Deflection 2mm(min)
60 sec minimum holding time
Meet Table A after testing.
22 Terminal Strength
Per AEC-Q200-006
A force of 17.7N for 60sec
No defects
30 Electrical Transient
Conduction
Per ISO-7637-2 Not Applicable
8. Measuring Terminal
(When measuring and suppling the voltage, the following terminal is applied.)
No. Item Measuring terminal
8.1
Inductance (L)
DC Resistance (Rdc)
8.2
Withstand voltage
Insulation Resistance (I.R.)
Biased Humidity
Operational Life
8.3 Common Mode Impedance(Zc)
9. Measuring method for common mode impedance.
Measured common mode impedance may be included measurement error due to stray capacitance, residual
inductance of test fixture.
To correct this error, the common mode impedance should be calculate as follows;
(1) Measure admittance of the fixture(opened), Go Bo.
(2) Measure impedance of the fixture(shorted), Rs Xs.
(3) Measure admittance of the specimen, Gm Bm.
(4) Calculate corrected impedance Z using the formula below.
Z = (Rx
2
+Xx
2
)
1/2
Where
Rx =
Gm - Go
(Gm-Go)
２
+ (Bm-Bo)
２
－ Rs
Xx =
- (Bm - Bo)
(Gm-Go)
２
+ (Bm-Bo)
２
－ Xs
N
OUT
I
OU T
I N
I
OU T
N
