Si4702/03-D30
30 Rev. 0.6
Reset value = 0x0100
Register 07h. Test 1
Bit D15 D14 D13D12D11D10D9 D8D7D6D5D4D3D2D1D0
Name XOSCEN AHIZEN Reserved
Type R/W R/W R/W
Bit Name Function
15 XOSCEN Crystal Oscillator Enable.
0 = Disable (default).
1 = Enable.
The internal crystal oscillator requires an external 32.768 kHz crystal as shown in
2. "Typical Application Schematic" on page 14. The oscillator must be enabled before
powerup (ENABLE = 1) as shown in Figure 9, “Initialization Sequence,” on page 21. It
should only be disabled after powerdown (ENABLE = 0). Bits 13:0 of register 07h
must be preserved as 0x0100 while in powerdown and as 0x3C04 while in powerup.
Refer to Si4702/03 Internal Crystal Oscillator Errata.
14 AHIZEN Audio High-Z Enable.
0 = Disable (default).
1 = Enable.
Setting AHIZEN maintains a dc bias of 0.5 x V
IO
on the LOUT and ROUT pins to pre-
vent the ESD diodes from clamping to the V
IO
or GND rail in response to the output
swing of another device. Register 07h containing the AHIZEN bit must not be written
during the powerup sequence and high-Z only takes effect when in powerdown and
V
IO
is supplied. Bits 13:0 of register 07h must be preserved as 0x0100 while in pow-
erdown and as 0x3C04 while in powerup.
13:0 Reserved Reserved.
If written, these bits should be read first and then written with their pre-existing val-
ues. Do not write during powerup.