ZL40220 Data Sheet
6
Microsemi Corporation
3.0 Functional Description
The ZL40220 is an LVDS clock fanout buffer with six identical output clock drivers capable of operating at
frequencies up to 750MHz.
The two Inputs to the ZL40220 are externally terminated to allow use of precision termination components and to
allow full flexibil
ity of input termination. The ZL40220 can accept DC or AC coupled LVPECL, LVDS, CML or HCSL
input signals; single ended input signals can also be accepted. A pin compatible device with internal termination is
also available.
The ZL40220 is designed to fan out
low-jitter reference clocks for wired or optical communications applications
while adding minimal jitter to the clock signal. An internal linear power supply regulator and bulk capacitors
minimize additive jitter due to power supply noise. The device operates from 2.5V+/-5% or 3.3V+/-5% supply. Its
operation is guaranteed over the industrial temperature range -40°C to +85°C.
The device block diagram is shown in Figure 1; its operation is described in the following sections.
3.1 Clock Input Selection
The select line chooses which input clock is routed to the outputs.
Table 1 - Input Selection
Sel Active Input
0 clk0
1 clk1
The following figure shows the expected clock
switching performance. The output stops at the first falling edge of
the initial clock after the select pin changes state. During switching there will be a short time when the output clock
is not toggling. After this delay, the output will start toggling again with a rising edge of the newly selected clock.
This behavior is independent of the frequencies of the input clocks. For instance, the two clocks could be at
different frequencies and the behavior would still be consistent with this figure.
2 µs
clk0
clk1
sel
outn
1
0
Figure 3 - Output During Clock Switch - Both Clocks Running
