AGQ200B-48S3V3 DC-DC Converter 12/14
http://www.emersonnetworkpower.com.cn
Pin Designations
Pin NO. Name Function
1 V
in
+ Positive input voltage
2 Remote ON/OFF Remote control
3 V
in
- Negative input voltage
4 V
o
- Negative output voltage
5 S- Negative remote sense
6 Trim Output voltage trim
7 S+ Positive remote sense
8 V
o
+ Positive output voltage
Soldering
The product is intended for standard manual or wave soldering.
When wave soldering is used, the temperature on pins is specified to maximum 260°C for
maximum 7s.
When manual soldering is used, the iron temperature should be maintained at 300°C ~ 380°C and
applied to the converter pins for less than 10s. Longer exposure can cause internal damage to the
converter.
Cleaning of solder joint can be performed with cleaning solvent IPA or similative.
Assembly
The maximum length of the screw driven into the heat-sink is 3.3mm.
Thermal Considerations
Note: When the temperature of this
test point is lower than 100℃, the
module thermal reliability is available
Figure 18 Temperature test point on converter
