TOWER SYSTEM Quick Start Guide for TWR-MCF51MM
Primary edge of TWR-MCF51MM and
TWR-SER must connect to this Primary
elevator, which has components on the
bottom of the board, including the mini-
USB connector.
This mini-USB port is only used for
OSBDM interface to program and debug
the MCF51MM256. It does not connect
to the MCF51MM256 USB ports.
Make sure this side is
the Secondary elevator..
Set Jumper J16 on TWR-SER
module to middle position
connecting pins 3 and 4 as shown.
This configures the module for
USB device mode, which is
required by the labs in this kit.
This mini-USB port on the
TWR-SER powers the whole
Tower System setup.
It interfaces with the
MCF51MM256 USB module.
Users can test the
MCF51MM256 USB via
this mini-USB port.
This is the TWR-SER module.
This is the mini-USB from the
Primary elevator. Connection
to this is not needed in this kit.
Figure 2: Tower System Assembled
NOTE: Figure 2 is a Tower System without the optional
MED-EKG assembly. For details on how to assemble the
MED-EKG, please refer to Lab 1 on the DVD.
