TSL267SM-LF

TSL267
HIGH-SENSITIVITY
IR LIGHT-TO-VOLTAGE CONVERTER
TAOS033E SEPTEMBER 2007
1
The LUMENOLOGY r Company
r
r
Copyright E 2007, TAOS Inc.
www.taosinc.com
D Integral Visible Light Cutoff Filter
D Converts IR Light Intensity to Output
Voltage
D Monolithic Silicon IC Containing
Photodiode, Operational Amplifier, and
Feedback Components
D High Sensitivity
D Single Voltage Supply Operation (2.7 V to
5.5 V)
D Low Noise (200 μVrms Typ to 1 kHz)
D Rail-to-Rail Output
D High Power-Supply Rejection (35 dB at
1 kHz)
D Compact 3-Leaded Plastic Package
D RoHS Compliant (LF Package Only)
Description
The TSL267 is a high-sensitivity low-noise infrared light-to-voltage converter that combines a photodiode and
a transimpedance amplifier on a single monolithic CMOS integrated circuit. Output voltage is directly
proportional to IR light intensity (irradiance) on the photodiode. The TSL267 has a transimpedance gain of
320 MΩ. The device has improved offset voltage stability and low power consumption and is supplied in a 3-lead
visible-light-blocking plastic sidelooker package with an integral lens.
Available Options
DEVICE T
A
PACKAGE LEADS PACKAGE DESIGNATOR ORDERING NUMBER
TSL267 0°C to 70°C 3-lead Sidelooker S TSL267
TSL267 0°C to 70°C 3-lead Sidelooker — Lead (Pb) Free S TSL267LF
TSL267 0°C to 70°C 3-lead Surface-Mount Sidelooker — Lead (Pb) Free SM TSL267SMLF
Functional Block Diagram
Voltage
Output
+
Terminal Functions
TERMINAL
DESCRIPTION
NAME NO.
DESCRIPTION
GND 1 Ground (substrate). All voltages are referenced to GND.
OUT 3 Output voltage
V
DD
2 Supply voltage
r
r
Texas Advanced Optoelectronic Solutions Inc.
1001 Klein Road S Suite 300 S Plano, TX 75074 S (972) 673-0759
PACKAGE S
SIDELOOKER
(FRONT VIEW)
1
GND
2
V
DD
3
OUT
PACKAGE SM
SURFACE MOUNT
SIDELOOKER
(FRONT VIEW)
1
GND
2
V
DD
3
OUT
TSL267
HIGH-SENSITIVITY
IR LIGHT-TO-VOLTAGE CONVERTER
TAOS033E SEPTEMBER 2007
2
r
r
Copyright E 2007, TAOS Inc.
The LUMENOLOGY r Company
www.taosinc.com
Absolute Maximum Ratings over operating free-air temperature range (unless otherwise noted)
Supply voltage, V
DD
(see Note 1) 6 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Output current, I
O
±10 mA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Duration of short-circuit current at (or below) 25°C 5 s. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operating free-air temperature range, T
A
25°C to 85°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Storage temperature range, T
stg
25°C to 85°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds (S Package) 260°C. . . . . . . . . . . . . . . . . . . .
Reflow solder, in accordance with J-STD-020C or J-STD-020D (SM Package) 260°C. . . . . . . . . . . . . . . . . . .
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTE 1: All voltages are with respect to GND.
Recommended Operating Conditions
MIN MAX UNIT
Supply voltage, V
DD
2.7 5.5 V
Operating free-air temperature, T
A
0 70 °C
Electrical Characteristics at V
DD
= 5 V, T
A
= 25°C, λ
p
= 940 nm, R
L
= 10 kΩ (unless otherwise noted)
(see Notes 2, 3, and 4)
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
V
D
Dark voltage E
e
= 0 0 15 mV
V
Maximum output voltage swing
V
DD
= 4.5 V, No Load 4.49
V
V
OM
Maximum output voltage swing
V
DD
= 4.5 V, R
L
= 10 kΩ 4 4.2
V
V
O
Output voltage E
e
= 4.4 μW/cm
2
1.2 2 2.8 V
α
VD
Temperature coefficient of dark voltage (V
D
) T
A
= 0°C to 70°C 15 μV/°C
N
e
Irradiance responsivity See Note 5 0.45 V/(μW/cm
2
)
PSRR Power supply rejection ratio
f
ac
= 100 Hz, see Note 6 55 dB
pp y j
f
ac
= 1 kHz, see Note 6 35 dB
I
DD
Supply current E
e
= 4.4 μW/cm
2
1.9 4 mA
NOTES: 2. Measured with R
L
= 10 kΩ between output and ground.
3. Optical measurements are made using small-angle incident radiation from a light-emitting diode (LED) optical source.
4. The input irradiance is supplied by a GaAs light-emitting diode with the following characteristics: peak wavelength λ
p
= 940 nm.
5. Irradiance responsivity is characterized over the range V
O
= 0.1 V to 4.5 V. The best-fit straight line of Output Voltage V
O
versus
Irradiance E
e
over this range will typically have a positive extrapolated V
O
value for E
e
= 0.
6. Power supply rejection ratio PSRR is defined as 20 log (ΔV
DD
(f)/ΔV
O
(f)) with V
DD
(f = 0) = 5 V and V
O
(f = 0) = 2 V.
TSL267
HIGH-SENSITIVITY
IR LIGHT-TO-VOLTAGE CONVERTER
TAOS033E SEPTEMBER 2007
3
The LUMENOLOGY r Company
r
r
Copyright E 2007, TAOS Inc.
www.taosinc.com
Switching Characteristics at V
DD
= 5 V, T
A
= 25°C, λ
p
= 940 nm, R
L
= 10 kΩ (unless otherwise noted)
PARAMETER TEST CONDITIONS MIN TYP MAX UNIT
t
r
Output pulse rise time, 10% to 90% of final value See Note 7 and Figure 1 160 250 μs
t
f
Output pulse fall time, 10% to 90% of final value See Note 7 and Figure 1 150 250 μs
t
s
Output settling time to 1% of final value See Note 7 and Figure 1 330 μs
Integrated noise voltage f = dc to 1 kHz E
e
= 0 200 μVrms
f = 10 Hz E
e
= 0 6
V
n
Output noise voltage, rms f = 100 Hz E
e
= 0 6 μV/Hz rms
n
pg,
f = 1 kHz E
e
= 0 7
μ /
NOTE 7: Switching characteristics apply over the range V
O
= 0.1 V to 4.5 V.
PARAMETER MEASUREMENT INFORMATION
VOLTAGE WAVEFORM
TEST CIRCUIT
Input
E
e
10%
90%
Output
(see Note B)
t
r
TSL267
R
L
V
DD
2
1
3
+
Output
Pulse
Generator
LED
(see Note A)
t
f
90%
10%
NOTES: A. The input irradiance is supplied by a pulsed GaAs light-emitting diode with peak wavelength: λ
p
= 940 nm,
t
r
< 1 μs, t
f
< 1 μs.
B. The output waveform is monitored on an oscilloscope with the following characteristics: t
r
< 100 ns, Z
i
1 MΩ, C
i
20 pF.
Figure 1. Switching Times

TSL267SM-LF

Mfr. #:
Manufacturer:
ams
Description:
Light To Frequency & Light To Voltage Light to Voltage Converter
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet