6
www.pericom.com PS9060A 08/23/11
PI3VDP411L SR
Dual Mode DisplayPort™ to DVI/HDMI™ Electrical Bridge (Level Shier)
Table: Power Supplies and Temperature Range
Symbol Parameter Min Typ Max Units Comments
V
DD
3.3V Power supply 3.0 3.3 3.6 V
I
CC
Max Current 100 mA
I
CCQ
Standby Current 2 mA OE# = HIGH
T
CASE
Case temperature range
for operation with spec.
-40 85 Celsius (°)
Table: Dierential Input Characteristics for IN_Dx signals
Symbol Parameter Min Typ Max Units Comments
T
bit
Unit Interval 360 ps
T
bit
is determined by the display
mode. Nominal bit rate ranges from
250Mbps to 2.5Gbps per lane. Nomi-
nal Tbit at 2.5 Gbps = 400 ps. 360ps =
400ps-10%
V
RX_DIFF
Input Dierential Volt-
0.175 1.200 V See note 1 below
T
RX_EYE
Minimum Eye Width at
IN_D input pair
0.8
T
bit
e level shier may add a maximum
of 0.02UI jitter (400 * 0.02) = 8ps
V
CM-ACp-p
AC Peak Common
Mode Input Voltage
100 mV See note 2 below
Z
RX_DC
40 50 60 Ω
Required IN_D+ as well as IN_D- DC
impedance (50 ±20% tolerance).
Z
RX-Bias
0 2.0 V
Intended to limit power-up stress on
chipset's PCIE output buers.
Z
RX_HIGH-Z
100 k Ω
Dierential inputs must be in a high
impedance state when OE# is HIGH.
1. V
RX-DIFF
= 2x|V
RX-D- -
V
RX-D-
| Applies to IN_Dx signals
2. V
CM-AC-p-p
= |V
RX-D
- - V
RX-D
-|/2 - V
RX-CM-DC
V
RX-CM-DC
= DC(avg) of |V
RX-D+
+ V
RX-D
-|/2
V
CM-AC-p-p
includes all frequencies above 30 kHz.
TMDS Outputs
e level shier's TMDS outputs are required to meet HDMI 1.3 specications.
e HDMI 1.3 Specication is assumed to be the correct reference in instances where this document conicts with the HDMI 1.3
specication.
