2903116

https://www.phoenixcontact.com/us/products/2903116

04/26/2016Page1/8

Hybrid motor starter-ELR H5-IES-SC-SWD/500AC-0,6-2903116

Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's

documentation. Our General Terms of Use for Downloads are valid

(http://phoenixcontact.com/download)

Hybrid motor starter for reversing 3~AC motors up to 550VAC, 0.6A output current, adjustable overload

shutdown and safe emergency stop up to PLe/SIL 3 and SmartWire-DT

™

adapter as a set.

Width 22.5 mm

Height 165 mm

Depth 114.5 mm

Ambient conditions

Ambient temperature (operation) -5 °C ... 55 °C (observe derating)

Ambient temperature (storage/transport) -40 °C ... 80 °C

Degree of protection IP20

Device supply

Rated control circuit supply voltage U

S

Surge protection

Input data

Input name Control input right/left

https://www.phoenixcontact.com/us/products/2903116

04/26/2016Page2/8

Hybrid motor starter-ELR H5-IES-SC-SWD/500AC-0,6-2903116

Technical data

Input data

Rated actuating voltage U

C

24 V DC

Voltage range 19.2 V DC ... 30 V DC

Typical turn-off time < 30 ms

Output data load output

Output name AC output

Rated operating voltage U

500 V AC

Operating voltage range 42 V AC ... 550 V AC

Mains frequency 50 Hz

60 Hz

Load current range 75 mA ... 600 mA (see to derating)

Note Confirmation: floating change-over contact, signal contact

Contact type 1 PDT

Switching capacity according to IEC 60947-5-1 3 A (230 V, AC15)

2 A (24 V, DC13)

General

Switching frequency ≤ 2 Hz (Load-dependent)

Mounting position vertical (horizontal DIN rail, motor output below)

Assembly instructions alignable, for spacing see derating

Operating mode 100% operating factor

Maximum power dissipation 2.5 W

https://www.phoenixcontact.com/us/products/2903116

04/26/2016Page3/8

Hybrid motor starter-ELR H5-IES-SC-SWD/500AC-0,6-2903116

Technical data

Connection data, input side

Connection name Control circuits

Connection method Screw connection

Stripping length 8 mm

Screw thread M3

Conductor cross section solid 0.2 mm² ... 2.5 mm²

Conductor cross section flexible 0.2 mm² ... 2.5 mm²

Conductor cross section AWG 24 ... 14

Torque 0.5 Nm ... 0.6 Nm

Connection data, output side

Connection name Load circuit

Connection method Screw connection

Standards/regulations

Designation Standards/regulations

Standards/regulations IEC60947-1

EN 60947-4-2

IEC 61508

ISO 13849

Insulation characteristics

Rated insulation voltage 500 V

Rated surge voltage 6 kV

Overvoltage category III

Basic isolation (IEC 60947-1) at operating voltage 300 ... 500 V AC

Safe isolation (EN 50178) at operating voltage 300 ... 500 V AC

Designation

Isolation characteristics between the control input and control supply

voltage to auxiliary circuit

Insulation Safe isolation (IEC 60947-1) in the auxiliary circuit ≤ 300 V AC