RPM872-H14
Photo Link Module
Rev.A 3/6
zTerminal description
Function
Pin No
1, 4 GND
GND
Pin1 and Pin4 must be connected to the
ground.
VIO
Supply voltage for I/O pins (PWDOWN,
RXD, TXD)
Power-down Control Terminal
CMOS logic level input
When input is H, it will stop the receiving
circuit, Pin-PD current and transmitting
LED operation.
H : POWERDOWN MODE
L : OPERATING MODE
Connect to Ground.
2 VIO
PWDOWN
RXD
TXD
LEDA
Shield Case
3
5
6
7
8
−
V
CC
VIO
VIO
600k
LED
VIO
VIO
PWDOWN
300k
V
CC
Supply voltage for Transceiver circuits.
For preventing from infection,
connect a capacitor between
V
CC
(3pin) and GND(4pin).
Receiving Data Output Terminal
CMOS logic level output
When PWDOWN (5pin) = H, the RXD
output will be pulled up to
VIO at approximately 300kΩ.
Transmitting Data Input Terminal
H : LED (PWDOWN = L)
CMOS logic level input
Holding TXD = "H"status, LED will
be turn off approximately 48µs.
LED ANODE Terminal
Other power source can be used
difference between LEDV
CC
and V
CC
.
This can be connected to battery kinds
of unregulated voltage source by internal
constant current driver.
Terminal Circuit