RPM872-H14
Photo Link Module
Rev.A 6/6
zNotes
1) VLEDA(8pin), VCC(3pin) and VIO(2pin)
•
Other power source can be used difference between VLEDA and VCC and VIO. (VIO < VCC +0.3V)
2) Caution in designing board lay-out
To get maximum potential from RPM872-H14, please keep in mind following instruction.
•
The line of RXD (6pin) should be connected at backside via through hole close to RPM872-H14 pin lead. Better not
to be close to photo diode side (1pin).
⇒This is to minimize feedback supplied to photo diode from RXD.
•
As for C1 between 3-4 pin should be placed close to RPM872-H14.
•
Better to be placed more than 1.0cm in radius from photo diode (pin1 side) and also away from the parts which
generates noise, such as DC / DC converter.
3) Others
•
Please be sure to set up the TXD (7pin) input to be “L” (under 0.3V) except transmitting data
(for < 90µs. On duty < 20%).
•
Powerdown current might increase if exposed by strong light (ex. direct sunlight) at powerdown mode.
•
Please use by the signal format which is specified by IrDA Ver1.2 (Low Power). There might be on error if used by
different signal format.
•
Dust or dirt on lens portion may affect the characteristics, so pay sufficient attention.
4) Eye Safe
•
IEC825-1 (EN60825-1) Class 1 Eye Safe.
zExternal dimensions (Unit : mm)
18
NOTE
UNIT : mm
A
LED
PinPD
1.TOLERANCE : ±0.2mm
2.COPLANARITY : 0.1mmMAX
ETH648
0.6
0.48
2.8
8.0
1.0
0.15±0.1
0.76
0.15±0.1
0.78
2.2
1.1
1.4
4.0
0.37±0.1
2.59
(0.13)
P0.95×7=6.65
0.95
2.2
0.75
2.67
R1.0
R1.1
0.68±0.1
0.6±0.1
2.9
A Part Size (Shield Case underside size)
2.2