DS2760
25
ELECTRICAL CHARACTERISTICS:
1-WIRE INTERFACE (-20°C to +70°C; 2.5V £ V
DD
£ 5.5V)
PARAMETER SYMBOL MIN TYP MAX UNITS NOTES
Time Slot t
SLOT
60 120 ms
Recovery Time t
REC
1 ms
Write 0 Low Time t
LOW0
60 120 ms
Write 1 Low Time t
LOW1
1 15 ms
Read Data Valid t
RDV
15 ms
Reset Time High t
RSTH
480 ms
Reset Time Low t
RSTL
480 960 ms
Presence Detect High t
PDH
15 60 ms
Presence Detect Low t
PDL
60 240 ms
SWAP timing pulse width t
SWL
0.2 120 ms
SWAP timing pulse
falling edge to
DC release
t
SWOFF
0 1 ms 12
SWAP timing pulse rising
edge to
DC engage
t
SWON
0 1 ms 12
DQ Capacitance C
DQ
60 pF
EEPROM RELIABILITY SPECIFICATION (-20°C to +70°C; 2.5V £ V
DD
£ 5.5V)
PARAMETER SYMBOL MIN TYP MAX UNITS NOTES
Copy to EEPROM Time t
EEC
2 10 ms
EEPROM Copy Endurance N
EEC
25000 cycles 11
NOTES
1) All voltages are referenced to VSS.
2) See “Ordering Information” section of datasheet to determine corresponding part number for each V
OV
value.
3) Internal current sense resistor configuration.
4) External current sense resistor configuration.
5) Self heating due to output pin loading and sense resistor power dissipation can alter the reading from ambient conditions.
6) Voltage offset measurement is with respect to V
OV
at +25°C.
7) The current register supports measurement magnitudes up to 2.56A using the internal sense resistor option and 64mV with
the external resistor option. Compensation of the internal sense resistor value for process and temperature variation can
reduce the maximum reportable magnitude to 1.9A.
8) Current offset error null to ±1LSB typically requires 3.5s in-system calibration by user.
9) Current gain error specification applies to gain error in converting the voltage difference at IS1 and IS2, and excludes any
error remaining after the DS2760 compensates for the internal sense resistor’s temperature coefficient of 3700ppm/°C to
an accuracy of ±500ppm/°C. The DS2760 does not compensate for external sense resistor characteristics, and any error
terms arising from the use of an external sense resistor should be taken into account when calculating total current
measurement error.
10) Typical value for t
ERR
is at 3.6V and +25°C.
11) 4-year data retention at +70°C.
12) Typical load capacitance on
DC and CC is 1000pF.
13) Test conditions are PLS = 4.1V, V
DD
= 2.5V. Maximum current for conditions of PLS = 15V, V
DD
=0V is 10mA.
14) Error at time of shipment from Dallas Semiconductor is 3% max. Board mounting processes may cause the current gain
error to widen to as much as 10% for devices with the internal sense resistor option. Contact factory for on-board
recalibration procedure for devices with the internal sense resistor option to improve accuracy.
