DS1743/DS1743P Y2K-Compliant, Nonvolatile Timekeeping RAMs
7 of 16
WRITING DATA TO RAM OR CLOCK
The DS1743 is in the write mode whenever WE, and CE are in their active state. The start of a write is
referenced to the latter occurring transition of WE, on CE. The addresses must be held valid throughout the
cycle. CE or WE must return inactive for a minimum of t
WR
prior to the initiation of another read or write
cycle. Data in must be valid t
DS
prior to the end of write and remain valid for t
DH
afterward. In a typical
application, the OE signal will be high during a write cycle. However, OE can be active provided that care
is taken with the data bus to avoid bus contention. If OE is low prior to WE transitioning low the data bus
can become active with read data defined by the address inputs. A low transition on WE will then disable
the outputs t
WEZ
after WE goes active.
DATA-RETENTION MODE
The 5V device is fully accessible and data can be written or read only when VCC is greater than VPF.
However, when V
CC
is below the power-fail point, V
PF
, (point at which write protection occurs) the
internal clock registers and SRAM are blocked from any access. At this time (PowerCap only) the power-
fail reset-output signal (RST) is driven active and remains active until V
CC
returns to nominal levels. When
V
CC
falls below the battery switch point V
SO
(battery supply level), device power is switched from the V
CC
in to the backup battery. RTC operation and SRAM data are maintained from the battery until V
CC
is
returned to nominal levels.
The 3.3V device is fully accessible and data can be written or read only when V
CC
is greater than V
PF
.
When V
CC
falls below the power-fail point, V
PF
, access to the device is inhibited. At this time the power-
fail reset-output signal (RST) is driven active and remains active until V
CC
returns to nominal levels. If V
PF
is less than V
SO
, the device power is switched from V
CC
to the backup supply (V
BAT
) when V
CC
drops
below V
PF
. If V
PF
is greater than V
SO
, the device power is switched from V
CC
to the backup supply (V
BAT
)
when V
CC
drops below V
SO
. RTC operation and SRAM data are maintained from the battery until V
CC
is
returned to nominal levels. The RST (PowerCap only) signal is an open-drain output and requires a pullup
resistor. Except for RST, all control, data, and address signals must be powered down when V
CC
is
powered down.
BATTERY LONGEVITY
The DS1743 has a lithium power source that is designed to provide energy for clock activity and clock and
RAM data retention when the V
CC
supply is not present. The capability of this internal power supply is
sufficient to power the DS1743 continuously for the life of the equipment in which it is installed. For
specification purposes, the life expectancy is 10 years at +25C with the internal clock oscillator running in
the absence of V
CC
power. Each DS1743 is shipped from Dallas Semiconductor with its lithium energy
source disconnected, guaranteeing full energy capacity. When V
CC
is first applied at a level greater than
V
PF
, the lithium energy source is enabled for battery backup operation. Actual life expectancy of the
DS1743 will be longer than 10 years since no lithium battery energy is consumed when V
CC
is present.
BATTERY MONITOR
The DS1743 constantly monitors the battery voltage of the internal battery. The battery flag bit (bit 7) of
the day register is used to indicate the voltage level range of the battery. This bit is not writeable and
should always be a 1 when read. If a 0 is ever present, an exhausted lithium energy source is indicated and
both the contents of the RTC and RAM are questionable.