TLP2166A
2014-09-22
2
Absolute Maximum Ratings (Ta=25°C)
CHARACTERISTIC SYMBOL RATING UNIT
LED
Forward Current (Note 1) I
F
15 mA
Forward current derating (Ta ≥ 95℃) (Note 1) ⊿I
F
/⊿Ta -0 .5 m A/ ℃
Peak Transient Forward Current (Note 1, 2) I
FP
1 A
Reverse Voltage (Note 1) V
R
5 V
DETECTOR
Output Current (Note 1) I
O
10 mA
Output Voltage (Note 1) V
O
6 V
Supply Voltage V
CC
6 V
Output Power Dissipation P
O
40 mW
Operating Temperature Range T
o
-40 to 100 °C
Storage Temperature Range T
st
-55 to 125 °C
Lead Soldering Temperature (10 s) T
sol
260 °C
Isolation Voltage (AC, 1 minute, R.H.≤ 60%,Ta=25°C) (Note 3) BV
S
2500 V
rms
Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the
significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if
the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum
ratings.
Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook
(“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test
report and estimated failure rate, etc).
Note 1: Each Channel.
Note 2: Pulse width ≤ 1 μs, 300 pps.
Note 3: This device is regarded as a two terminal device: pins 1, 2, 3 and 4 are shorted together,
as are pins 5, 6, 7 and 8.
Recommended Operating Conditions
CHARACTERISTIC SYMBOL MIN TYP. MAX UNIT
Input Current, ON (Note 1) I
F
ON
5 ― 10 mA
Input Voltage, OFF (Note 1) V
F
OFF
0 ― 0.8 V
Supply Voltage* (Note 4) V
CC
3.0 3.3 3.6 V
Operating Temperature T
opr
-40 ― 100 °C
* This item denotes operating range, not meaning of recommended operating conditions.
Note 4: The detector of this product requires a power supply voltage (V
CC
) of 3.0 V or higher for stable operation.
If the V
CC
is lower than this value, an I
CCH
may increase, or an output may be unstable.
Be sure to use the product after checking the supply current, and the operation of a power-on/-off
Note 5: A ceramic capacitor (0.1 μF) should be connected from pin 8 (V
CC
) to pin 5 (GND) to stabilize the operation of
the high gain linear amplifier. Failure to provide the bypass may impair the switching property.
The total lead length between capacitor and coupler should not exceed 1 cm.