Data Sheet HMC520A
Page 27 of 28
EVALUATION BOARD INFORMATION
The EV1HMC520ALC4 evaluation PCB used in the application
must use RF circuit design techniques. Signal lines must have
50 Ω impedance and connect the package ground leads and
exposed pad directly to the ground plane similarly to that shown
in Figure 84. Use a sufficient number of via holes to connect the
top and bottom ground planes. The evaluation circuit board shown
in Figure 84 is available from Analog Devices, Inc., upon request
13605-085
Figure 84. EV1HMC520ALC4 Evaluation PCB Top Layer
Table 10. Bill of Materials for the
EV1HMC520ALC4 Evaluation PCB
Quantity Reference Designator Description Part Number
1 109996-1 PCB, EV1HMC520ALC4 109996-1
2 J1, J2 (RF, LO) 2.92 mm SMA connectors, SRI Connector Gage 104935
2 J3, J4 (IF1, IF2) Gold plated SMA, edge mount with 0.02 inch pin connectors, Johnson SMA connectors 105192
1 U1 Device under test, HMC520ALC4 HMC520ALC4