Additive Jitter at 2.5 V*
Output Frequency (MHz) Jitter
Measurement
Filter
Typical
(f
s)
Notes
1 125 12 kHz - 20 MHz 105
2 212.5 12 kHz - 20 MHz 108
3 311.04 12 kHz - 20 MHz 96
4 425 12 kHz - 20 MHz 79
5 500 12 kHz - 20 MHz 69
6 622.08 12 kHz - 20 MHz 56
7 750 12 kHz - 20 MHz 41
Additive Jitter at 3.3*V
Output Frequency (MHz) Jitter
Measurement
Filter
Typical
(f
s)
Notes
1 125 12 kHz - 20 MHz 108
2 212.5 12 kHz - 20 MHz 108
3 311.04 12 kHz - 20 MHz 97
4 425 12 kHz - 20 MHz 79
5 500 12 kHz - 20 MHz 69
6 622.08 12 kHz - 20 MHz 56
7 750 12 kHz - 20 MHz 40
ZL40203 Data Sheet
19
Microsemi Corporation
5.0 Performance Characterization
*The values in this table were taken with an aproximate slew rate of 0.8 V/ns.
*The values in this table were taken with an aproximate slew rate of 0.8 V/ns.
Additive Jitter from a Power Supply Tone*
Carrier
f
requency
Parameter Typical Units Notes
125MHz 25 mV
at 100 kHz
141 fs RMS
750MHz 25 mV
at 100 kHz
82 fs RMS
* The values in this table are the additive periodic jitter caused by an interfering tone typically caused by a switching power supply. For this test,
measurements were taken over the full temperature and voltage range for V
DD
= 3.3 V. The magnitude of the interfering tone is measured at the
DUT.
