2004 - 2016 Microchip Technology Inc. DS00002119A-page 21
USB2601/USB2602
Note 6-4 Output leakage is measured with the current pins in high impedance.
Note 6-5 See Appendix A for USB DC electrical characteristics.
Note 6-6 The Maximum power dissipation parameters of the package should not be exceeded
Note 6-7 The assignment of each Integrated Card Power FET to a designated Card Connector is controlled
by both firmware and the specific board implementation. Firmware will default to the settings listed in
Table 8-1, “GPIO Usage (ROM Rev -01),” on page 25.
Integrated Power FET for
GPIO11
Output Current
Short Circuit Current Limit
On Resistance
Output Voltage Rise Time
I
OUT
I
SC
R
DSON
t
DSON
200
181
2.1
800
mA
mA
s
GPIO11;
Vdrop
FET
= 0.46V
GPIO11;
Vout
FET
= 0V
GPIO11;
I
FET
= 70mA
GPIO11;
C
LOAD
= 10F
Supply Current Hub, Card Read-
er, Unconfigured
High-Speed Host
Full-Speed Host
I
CCINIT
I
CCINIT
90
83
mA
mA
Supply Current
Configured
(High-Speed Host)
3 Ext Ports @HS
Card Reader Active
302 mA
Total from all supplies
Supply Current
Configured
(High-Speed Host)
1 Ext Port @HS
Card Reader Active
242 mA
Total from all supplies
Supply Current
Configured
(Full-Speed Host)
1 Ext Port @ FS/LS
Card Reader Active
200 mA
Total from all supplies
Supply Current
Suspend
I
CSBY
298 mA Total from all supplies.
Supply Current
Reset
I
RST
91 mA Total from all supplies.
Parameter Symbol MIN TYP MAX Units Comments
