NCP59800
www.onsemi.com
2
Figure 2. Internal Block Diagram − Adjustable Voltage Option
Table 1. PIN FUNCTION DESCRIPTION
Pin No. DFN8 Pin Name Description
7,8 IN Unregulated input supply.
4, EPAD GND Ground.
5 EN Driving the enable pin (EN) high turns on the regulator.
Driving this pin low puts the regulator into shutdown mode.
6 NR Connect an external capacitor between this pin and ground to reduce the output noise to very
low levels. The capacitor slows down the V
OUT
ramp as well (soft−start).
Max recommended C
NR
value is 0.47 mF
3
(Adjustable devices)
FB This pin is the input to the control loop error amplifier and is used to set the output voltage of
the device.
3
(Fixed Volt devices)
SNS This pin is the input to the control loop error amplifier and is used to set the output voltage of
the device. This pin is to be joined with OUT at load devices.
1,2 OUT
Regulator output. A 4.7 mF to 100 mF capacitor of any type is required for stability. R
ESR
≤
1 W
Table 2. ABSOLUTE MAXIMUM RATINGS
Rating Symbol Value Unit
Input Voltage (Note 1) IN 6.5 V
Output, Sense Voltage OUT, SNS −0.3 to (V
IN
+ 0.3) ≤ 6.5 V
Enable Input EN −0.3 to 6.5 V
Other Voltages FB, NR −0.3 to 3.6 V
Output Current I
OUT
Internally Limited mA
Maximum Junction Temperature T
J(MAX)
150 °C
Storage Temperature T
STG
−55 to 150 °C
ESD Capability, Human Body Model (Note 2) ESD
HBM
2000 V
ESD Capability, Machine Model (Note 2) ESD
MM
200 V
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality
should not be assumed, damage may occur and reliability may be affected.
1. Refer to ELECTRICAL CHARACTERISTICS and APPLICATION INFORMATION for Safe Operating Area.
2. This device series incorporates ESD protection and is tested by the following methods:
ESD Human Body Model tested per AEC−Q100−002 (EIA/JESD22−A114)
ESD Machine Model tested per AEC−Q100−003 (EIA/JESD22−A115)
Latchup Current Maximum Rating tested per JEDEC standard: JESD78