16
E3X E3X
16
Tightening Force
The tightening force applied to the Fiber Unit should be as
follows:
Precautions
■ FIBER UNITS
Screw-mounting Model
Use a proper-sized spanner.
Nuts
(attachment)
Toothed washers
Retaining screw
(M 3 max.)
Clamping torque
3 kgf • cm max.
Column Model
Fiber Connection and Disconnection
The E3X amplifier has a lever lock. Connect or disconnect the
fibers to or from the E3X amplifier using the following
procedures:
Fiber units Clamping torque
M3/M4 screw 8 kgf • cm max. (0.78 N • m)
M6 screw 10 kgf • cm max. (0.98 N • m)
2-mm dia. column 3 kgf • cm max. (0.29 N • m)
3-mm dia. column 3 kgf • cm max. (0.29 N • m)
E32-D14L 10 kgf • cm max. (0.98 N • m)
E32-T12F 8 kgf • cm max. (0.78 N • m)
E32-D12F 8 kgf • cm max. (0.78 N • m)
E32-T16 5 kgf • cm max. (0.49 N • m)
E32-R21 6 kgf • cm max. (0.59 N • m)
E32-M21 Up to 5 mm to the tip: 5 kgf • cm
max. (0.49 N • m)
Up to 5 mm from the tip: 8 kgf • cm
max. (0.78 N • m)
E32-L25A 8 kgf • cm max. (0.78 N • m)
Spring mounting clip
1. Connection
Insertion mark
Fiber
Insert the fibers into the E3X amplifier and press the lever
lock until the amplifier clicks to lock the fibers. The fibers will
have insertion marks when they are cut with the E39-F4
(Fiber Cutter). The portion from the tips to the insertion mark
should be inserted to the E3X.
2. Disconnection
Raise the lock lever to unlock the fibers before pulling
them out.
Fiber Insertion
If the portion from the tip to the insertion mark of the fibers are
not inserted into the amplifier unit, the sensing distance will be
reduced.
Lever lock
Locked
Unlocked