User Manual – AS5x61/AS5x62 Programming
Figure 1 AS5x6y GUI
3) Choose the right device AS5162(singleDIE) or AS5262(dualDIE)
4) Click
5) Enter beginning angle, T1. Two methods are possible:
a. Manually enter an initial position value into “T1 Cordic” field or “T1 (°),or
b. Move magnet assembly to initial position and click “Get”. This will take the value
related to the magnet current physical location as the Cordic register initial position.
6) Enter final angle, T2. Two methods are possible, except that this position is the final
position of the magnet’s rotation.
a. Manually enter a final position value into “T2 Cordic” field or “T2 (°)”, or
b. Move magnet assembly to final position and click “Get”. This will take the value
related to the magnet current physical location as the Cordic register initial position.
7)
8) Enter This is V
OUT
at the initial magnet position.
9) Enter This is V
OUT
at the final magnet position.
10) Enter Clamping Level Low is the voltage at the lower guard band.
11) Enter Clamping Level High is the voltage at the upper guard band.
