Note:
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’ s specifications are subject to change or our
products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
specifications or transact the approval sheet for product specifications before orderin
.
2010.5.7
MPD6D10*S Specification
9
9.2.6. Synchronous Turn-on/off
The Isolated DC-DC Converters running for multiple and / or parallel operation are enable to
synchronize turn-on/off timing among the running converters, of which the input voltage detection
circuits are unified to the detection voltage of a certain Isolated DC-DC Converter. Every PO pin is
necessary to be connected for multiple and/or parallel operation. Maximum number running DC-DC
Converters is 10pcs.To connect more than 10,please consult Murata.
9. 3. Reliability
9.3.1. Humidity Test
Parts are subjected to a temperature 40°C
±2°C with 90∼95% for 100 hours.
Return the parts to room temperature (25°C) for 4 hours and measure. The initial values under item
9.1. should be met. (JIS-C-0022)
9.3.2. Thermal Cycle Test
Parts are subjected to 5 cycle of the following.
The parts are placed in room temperature (25°C) for 2 hours and are measured.
The initial values under item 9.1. should be met.
Step Condition Time
1
-40±3°C
30 minutes
2
Room Temp. 5∼10 minutes
3
+85±3°C
30 minutes
4
Room Temp. 5∼10 minutes
9.3.3. Vibration
10 to 55Hz, 1.5mm amplitude, 1 hour for each each of X,Y,Z directions.
No damage in appearance and no deviation from electrical characteristics(9.1.).
9.3.4. Mechanical Shock
20G, 1 time for each X,Y,Z directions.
No damage in appearance and no deviation from electrical characteristics(9.1.).
9.3.5. Soldering Heat Resistance
Immerse the part of lead where it is to be soldered on a motherboard in a solder bath of 260
±5°C
for 3
±0.5s.
Then tested products are left for 2 hours.
There is no damage in appearance and no deviation from electrical characteristics in clause 9.1.
9.3.6. Lead Pin Strength
Strain a lead pin by gradual-increasingly 5.0N along axial direction; withstand for 5s.
No damage on a lead pin.
9.3.7. Solderability of Leads
The lead pins will be immersed in the Isopropyl Alcohol (JIS K 1522) with Rosin (JIS K 5902)
solution (the concentration of Rosin will be allowed 10wt% to 35wt%, and normally approx.25wt%
will be used without any specific requirement.). Then the lead pins will be immersed in the solder
H63A (JIS Z 3282) solution at the temperature of 230°C
±5°C for 3±0.5seconds, and pulled up
completely. The solder will adhere to over 75% of immersed area.
