IBS OPTOSUB-MA/M/R-LK-OPC(-2MBD)
5571D 5
Installation
Figure 3 Connection examples
Connecting the Converter to the Controller
Board
• Insert the converter into the INTERBUS
interface of your controller board.
• Tighten the two screws manually with a
bladed type screwdriver
(e.g., SZF 1-0,6X3,5) through the openings
above and below the diagnostics display.
An external voltage supply is not required for the
converter. The converter is supplied via the
INTERBUS interface.
Connecting Optical Fibers
Please refer to the Optical Fiber
Installation Guidelines
DB GB IBS SYS FOC ASSEMBLY
when assembling polymer fiber
cables.
Recommended F-SMA connector with bending
protection: PSM-SET-FSMA/4-KT.
• Fit both wires of the polymer fiber cables
with F-SMA connectors.
• Plug the F-SMA connectors into the
connections provided and secure the
connection with the cap nuts.
Please note that you must always connect
sender and receiver with one another.
The label for the optical fiber
connection (black arrow/orange
arrow) corresponds to the color of the
optical fiber cables.
Connect the individual optical fiber
cables between adjacent terminals
according to their color (e.g., orange
cable for orange connections).
R E M O T E O U T
F O 1
I B
D I A G
I N
O U T
R E M O T E I N
I N T E R B U S
7
5 5 7 1 A 0 0 2
I B S R L 2 4 B K R B - L K
2 4 V D C
F
U
S
E
F
U
S
E
I
N T E R
B
U S -
S
M o d u l e I d e n t . : 1 8 5
F
U
S
E
I
N T E R
B
U S -
S
F
U
S
E
R E M O T E I N
R E M O T E O U T
I B S S T ( Z F ) 2 4 B K M - L K - O P C
R E M O T E O U T
F O 1
I B
D I A G
I N
O U T
R E M O T E I N
I N T E R B U S
C o n t r o l l e r
b o a r d
C o n t r o l l e r
b o a r d
