ICE-1000/ICE-2000 Emulator User’s Guide 1-5
Getting Started
Configuring Operating Voltage of the JTAG/SWD
Interface on an ICE-2000
Determine the operating voltage of the JTAG/SWD interface of the target
processor. On the ICE-2000 emulator, the voltage is configured when
making a platform using the configurator. The default voltage is 3.3V.
Refer to the online help for information about “target configurator”.
Before connecting to a target, see the power-up/down procedures
in Applying Power to the Emulator.
Verifying Driver Installation and Attaching to an
Emulation Target
Before using the emulator, verify that the driver software is installed
properly.
1. Open the Windows Device Manager and verify that the ICE-1000
or ICE-2000 emulator appears under CrossCore Tools, as shown
in Figure 1-2.
2. When connecting to a 10-pin header on a target board, connect to
either the 6" cable when using the ICE-2000 or to the (J2) connec-
tor (located on the bottom of the board) when using the ICE-1000.
The 10-pin housing is keyed to ensure that the signals mate cor-
rectly with the 10-pin target emulation header. The target board
should also have keyed housing. Refer to Figure 1-3 for the J2 and
cable pinout information.
